Filter
Top Products
Connecting up
02
10
En
1 Connect the Xbox 360 to your TV and the receiver
subwoofer.
a. Connect the Xbox 360 Component HD AV Cable (this
is supplied with your Xbox 360) to the AV port on the
rear of the Xbox 360 console.
Plug the yellow video plug into a video input on your
TV/monitor. Plug the red/white audio plugs into the
audio inputs on your TV/monitor.
If your TV has a component video input, you can use
this instead of the yellow (composite) video
connection. See your Xbox 360 user manual for more
information.
b.Plug an optical cable (supplied) into the
XBOX 360
(OPTICAL)
jack on the rear of the receiver subwoofer,
then plug the other end into the digital audio output
on the HD AV Cable.
2 Connect the display unit to the receiver subwoofer.
Plug the L-shaped end of the display cable into the
connector on the rear of the display unit, then plug the
other end of the display cable into
SYSTEM
CONNECTOR
jack on the receiver subwoofer.
• To attach the stands to the display unit, slip the two
spurs on the top of each stand into the
corresponding holes on the rear of the display unit,
then snap the stand into place by pushing the
catches on the stand base into the bottom set of
holes (as shown).
3 Assemble the AM loop antenna.
a. Bend the stand in the direction indicated by the
arrow.
b.Clip the loop onto the stand.
c. If you want to fix to a wall or other surface, perform
step b after first securing the stand with screws.
It is recommended that you determine the reception
strength before securing the stand with the screws.
4 Connect the AM and FM antennas
1
.
a. Connect one wire of the AM loop antenna to each AM
antenna terminal
2
.
For each terminal, press down on the tab to open;
insert the wire, then release to secure.
b. Push the FM antenna
3
plug onto the center pin of the
FM antenna socket.
5 Connect each speaker.
• Each speaker cable has a color-coded connector at
one end and two wires at the other end.
• Twist and pull off the protective shields on each wire.
• Connect the wires to the speaker. Match the colored
wired with the color-coded label (model label), then
insert the colored wire into the red (
+
) side and the
other wire into the black (
–
) side.
a
b
c
Note
1• Keep antenna cables away from other cables, the display unit, receiver subwoofer and DVD recorder.
• If reception with the supplied antenna is poor, see
Improving poor FM reception
and
Improving poor AM sound
on page 22 or
Connecting
external antennas
on page 26.
2• Don’t let it come into contact with metal objects and avoid placing near computers, television sets or other electrical appliances.
• The signal earth (
) is designed to reduce noise that occurs when an antenna is connected. It is not an electrical safety earth.
• If radio reception is poor, you may be able improve it by re-inserting each antenna wire into the opposite terminal.
• For best reception, do not untwist the AM loop antenna wires or wrap them around the loop antenna.
3• To ensure optimum reception, make sure the FM antenna is fully extended and not coiled or hanging at the rear of the unit.
2
1
Color-coded wire
(Connect to speaker)
Color-coded connector
(Connect to rear panel)
SX-X360_WV.book 10 ページ ２００６年４月２１日 金曜日 午後５時３６分