Filter
Top Products
Speaker Setup Guide
01
6
En
Chapter 1
Speaker Setup Guide
Safety precautions when setting up
When assembling the speakers, lay them down flat on
their side to avoid accidents or injury. Make sure to use a
stable surface when assembling, setting up, and placing
the speakers.
• Attach the smaller non-skid pads to the base of each
of the front speakers and the center speaker. The four
large non-skid pads are for the receiver subwoofer (as
shown).
Use the supplied adhesive to attach 4 pads to the base
(flat surface) of each speaker.
Home theater sound setup
Depending on the size and characteristics of your room,
you can place your speakers in one of two ways using this
system:
Standard surround setup
This is a standard multichannel surround sound speaker
setup for optimal 5.1 channel home theater sound. Use
this setup together with
Auto listening mode
on page 18
or other listening mode.
• Connect the speaker system.
Refer to
Connecting up
to connect the speakers properly.
After connecting everything, place the speakers as
shown in the diagram (above) for optimal surround
sound.
After placing the speakers, run the Auto MCACC setup
(page 16) to complete your surround sound setup.
Non-skid pads
(small) x 12
Front speakers
Center speaker
Non-skid pads
(large) x 4
Receiver subwoofer
Surround
left
Surround
right
Listening position
Receiver subwoofer
Center
Front
left
Front
right
SX-X360_WV.book 6 ページ ２００６年４月２１日 金曜日 午後５時３６分