Pioneer S-X360 Speaker User Manual


 
Additional information
09
33
En
English
Tuner
Error Messages
Problem
Remedy
Considerable noise in
radio broadcasts.
• Connect the AM antenna (refer to the Connecting up) and adjust the direction and position for
best reception. You may also connect an additional internal or external AM antenna (refer to
Connecting external antennas
on page 26).
• Fully extend the FM wire antenna, position for best reception, and secure to a wall. You may also
connect an outdoor FM antenna (see
Connecting external antennas
on page 26).
• Turn off other equipment that may be causing the noise or move it further away.
Auto tuning does not
pick up some stations.
• The radio signal is weak. Auto tuning will only detect radio stations with a good signal. For more
sensitive tuning, connect an outdoor antenna.
Message
Description
2CH ONLY
• An operation is prohibited because it is only applicable to 2 channel sources, while the current
source is a multichannel source.
96K
• An operation is prohibited because the source is 96 kHz digital.
EXIT
• Appears when a menu is automatically exited after a set period of inactivity.
NOISY
• Background noise is too high to complete MCACC setup successfully.
ERR MIC
• An error occurred during MCACC setup because the microphone is not connected or is not
connected properly.
ERR SP
• An error occurred during MCACC setup because the speakers are not connected or are not
connected properly.
EEP ERROR
• Contact your Pioneer authorized service center or your dealer for servicing.
NO SPTYP
• Try switching the unit off then on again. If the error still appears, please contact a Pioneer
authorized service center or your dealer.
SX-X360_WV.book 33 ページ 2006年4月21日 金曜日 午後5時36分