Filter
Top Products
Surround sound and other settings05
22
En
•
LFE Off
– LFE channel is not played
DTS CD setting
If you play a DTS-encoded CD, you will need to
change this setting to hear the decoded signal.
When
CD Type?
appears, press
ENTER
, then
use
/
to select the setting:
•
NormalCD
– Regular CD playback, DTS-
encoded CDs output a noisy signal
•
DTS-CD
– Proper decoding of DTS-
encoded CDs, but regular CD playback
may lose quality
Setting the channel levels
You can set the relative channel levels from
your main listening position for all of the
listening modes independently.
1
If you have completed
Using the Auto MCACC
setup for optimal surround sound
on page 6,
the channel levels will already be set. You can
still fine-tune the levels here if you need to.
1 Select a listening mode.
Press
SURROUND
,
ADVANCED
or
FRONT
SURROUND
repeatedly to select the listening
mode you want.
2
2 Press
TEST TONE
to hear the test tone.
The test tone is output in the following order
(from the speakers active in the current mode):
•
L
– Front left speaker
•
C
– Center speaker
•
R
– Front right speaker
•
RS
– Right surround speaker
•
LS
– Left surround speaker
•
SW
– Subwoofer
3
3 Use the
MASTER VOLUME
+/– button to
adjust the volume to an appropriate level.
Turn down the volume to
40
or less to ensure
you have adequate headroom.
4 Use
/
to adjust the speaker levels in
turn.
You should hear the test tone at the same
volume from each speaker when seated in the
main listening position. The channel level
range is ± 10 dB.
5 When you’re done, press
ENTER
to exit
the test tone setup.
Note
1• The
SURROUND
modes are divided into two independent groups: multichannel listening modes and stereo modes.
• The speaker volume can be adjusted while listening to any sound source you want by pressing
CH LEVEL
and then using
/
to adjust the channel levels. After finishing a channel, use
/
to move to the next.
2 When the
Auto
listening mode is selected, using the test tone method will adjust levels for multichannel sources only. Use
CH LEVEL
and
/
(see footnote above) to set levels for the
Auto
listening mode with two channel sources.
STANDBY/ON
CD FM/AM
OPEN CLOSE
DVD TUNER TV LINE
L1/L2
4
4
0
1¡
8
7
3
FRONT
SURROUND
4
4
DVD MENU
RETURN
MUTE
7
ENTER
MASTER
VOLUME
BASS
MODE
SR+
123
REPEAT
AUDIO ANGLE
RANDOM
SUBTITLE
PROGRAM
4 5 6
7 9
MAIN SUB
ENTER
5
SUB
0
CLR
8
TEST TONE CH LEVEL
ZOOM
TOP MENU
DIMMER
DISPLAY
ADVANCED
SOUND
DIALOGUE
SURROUND
SETUP
SYSTEM
MIDNIGHT
QUIET/
CLOCK
TIMER/
3 Since the subwoofer produces ultra-low frequencies its sound may seem quieter than it actually is.
XV-DV333-434.book 22 ページ ２００５年２月２３日 水曜日 午後１時５２分