Filter
Top Products
Getting started01
10
En
•
Manual tuning
: Press
TUNE +/–
repeatedly to change the displayed
frequency.
•
Auto tuning
: Press and hold
TUNE +/–
until the frequency display starts to move,
then release. The tuner will stop on the next
station it finds. Repeat to keep searching.
•
High-speed tuning
: Press and hold
TUNE
+/–
until the frequency display starts to
move rapidly. Keep the button held down
until you reach the frequency you want. If
necessary, fine tune the frequency using
the manual tuning method.
Improving poor FM reception
If you’re listening to an FM station in stereo but
the reception is weak, you can improve the
sound quality by switching to mono.
1 Tune to an FM radio station then press
SYSTEM SETUP
.
2 Use
/
to choose ‘FM Mode?’ then
press
ENTER
.
3 Use
/
to select ‘FM Mono’ then press
ENTER
.
The mono indicator ( ) lights when the tuner
is in mono reception mode.
Select
FM Auto
above to switch back to auto-
stereo mode (the stereo indicator ( ) lights
when receiving a stereo broadcast).
Memorizing stations
You can save up to 30 station presets so that
you always have easy access to your favorite
stations without having to tune in manually
each time
1
.
1 Tune to an AM or FM radio station.
For the FM band, select mono or auto-stereo
reception as necessary. This setting is saved
along with the preset.
2 Press
SYSTEM SETUP
.
3 Use
/
to choose ‘St. Mem?’ then press
ENTER
.
4 Use
/
to select the station preset you
want then press
ENTER
.
Listening to station presets
1 Make sure the
TUNER
function is selected.
2 Use the
ST +/–
buttons to select a station
preset.
• You can also use the number buttons to do
this.
Listening to other sources
You can connect up to three external sources
(TV, satellite receiver, etc.) to this system,
including one digital source. See also
Connecting auxiliary components
on page 29.
1 Make sure that the external source (TV,
satellite receiver, etc.) is switched on.
2 Select the source you want to listen to.
• If you’re using the remote, press
TV
to
select the
TV IN
input, or use the
LINE
(
L1/
L2
) button to select
LINE 1
or
LINE 2
input.
2
3 If necessary, start playback of the source.
Tip
• If an auxiliary source is producing
unpleasant distortion from the speakers,
you can reduce the signal level (connected
to the
LINE 1
analog inputs) by switching
on the attenuator. See
Optional system
settings
on page 37 to do this.
Note
1 If the system is unplugged, saved stations will remain for several days, after which you’ll have to save them again.
2 When you press
TV
,
TV ATT
shows in the display. Pressing
LINE
switches between
L1 ATT
(analog) and
LINE2
(digital).
L1/L2CD FM/AM
DVD TUNER
TV LINE
FRONT
XV-DV333-434.book 10 ページ ２００５年２月２３日 水曜日 午後１時５２分