Filter
Top Products
Surround sound and other settings
05
21
En
English
Français
Deutsch
Nederlands
Italiano
Español
Chapter 5
Surround sound and other settings
Using the System Setup menu
All the available settings in the setup menu are
listed in
Surround and sound setup options
below. See the notes in each section for
additional information about the settings.
Follow the steps below to customize the
settings in the System Setup menu.
1
1 Press
SYSTEM SETUP
.
2 Use
/
to choose the setting you want
to adjust.
The current setting is shown for each option as
you cycle through the display. See below for a
full list and description of each.
3 Use
/
to adjust.
4 Repeat steps 2 and 3 for other settings.
5 When you’re done, press
ENTER
to leave
the System Setup menu.
Surround and sound setup options
Using the Auto MCACC setup for optimal
surround sound
on page 6 should give you the
best surround sound setup, but you may find
that by adjusting the following settings you can
improve the surround sound in your listening
room. The first setting in each section is the
default.
Speaker distance setting
Specifies the distance from your listening
position to your speakers.
When
Dist.?
appears, press
ENTER
, then use
/
to adjust the distance, and
/
to
switch between the following speakers:
•
L
– Front left speaker
•
C
– Center speaker
•
R
– Front right speaker
•
RS
– Surround right speaker
•
LS
– Surround left speaker
•
SW
– Subwoofer
Each speaker can be adjusted between
0.3 m
~
9.0 m
. The default setting is
3.0 m
.
Dynamic Range Control
Specifies dynamic range adjustment to Dolby
Digital or DTS soundtracks:
2
•
DRC Off
– No dynamic range adjustment
(use when listening at higher volume)
•
DRC Mid
– Mid setting
•
DRC High
– Dynamic range is reduced
(loud sounds are reduced in volume while
quieter sounds are increased)
LFE attenuator setting
Dolby Digital and DTS audio sources include
ultra-low bass tones. Set the LFE attenuator as
needed to prevent the ultra-low bass from
distorting the sound.
•
LFEATT 0
– No attenuation
•
LFEATT 10
– LFE channel attenuated 10dB
Note
1• The System Setup menu is exited automatically after 5 minutes of inactivity.
• You can't change the
Surround and sound setup options
with the Recording Mode (page 30) switched on.
• The
Speaker distance setting
and
DTS CD setting
require additional steps. Read the sections on each for more details.
2 This setting works only with Dolby Digital and some DTS soundtracks. For other sources, you can create a similar effect using
the Midnight mode (see
Using Quiet and Midnight listening modes
on page 13).
XV-DV333-434.book 21 ページ ２００５年２月２３日 水曜日 午後１時５２分