Filter
Top Products
43
Other Functions
Changing the display form
This product is equipped with two basic dis-
plays. You can select the desired display.
1. Press NEXT to display “C.MENU”.
Press NEXT until “C.MENU” appears.
2. Press C.MENU and then press D.FORM to
select the display form mode.
3. Press either FORM 1 or FORM 2 to select
the desired display form.
Adjusting the brightness
Display brightness adjustment lets you adjust
the display for easier viewing when lighting con-
ditions change.
1. Press NEXT to display “C.MENU”.
Press NEXT until “C.MENU” appears.
2. Press C.MENU and then press BRGHT to
select the brightness mode.
3. Press 2 or 3 to adjust the brightness.
Each press of 2 or 3 increases or decreas-
es the brightness.
•“00” – “31” is displayed as the brightness is
increased or decreased.
Switching the dimmer setting
To prevent the display from being too bright at
night, the display is automatically dimmed when
the car’s headlights are turned on. You can
switch the dimmer on or off.
1. Press NEXT to display “C.MENU”.
Press NEXT until “C.MENU” appears.
2. Press C.MENU and then press DMMER to
select the dimmer mode.
3. Press DMMER to turn the dimmer on.
“ON” appears on the display.
• Press DMMER again to turn the dimmer off.
Selecting the wall paper pattern
The wall paper pattern is only for display form 2
“FORM 2”, and there are three patterns to
choose from.
• When you select “FORM 1”, “PTRN” is not
displayed and this mode is inactive.
1. Press NEXT to display “C.MENU”.
Press NEXT until “C.MENU” appears.
2. Press C.MENU and then press PTRN to
select the wall paper pattern mode.
3. Press any of the buttons A – C to select
the desired pattern.
Setting the entertainment display
You can change the display to the movie
screens, the spectrum analyzer displays, etc.,
while listening to any source.
Setting the movie screen
There are two stored movie screens to select
from.
1. Press ENT and then press MOVIE to
select the movie mode.
2. Press any of the buttons MOVIE1,
MOVIE2 or ALL to select the desired
movie.
• When you press ALL, you can display
movies 1 and 2 sequentially.
Note:
• The movie screen will disappear temporarily when
you perform other operations, but will be displayed
again after three seconds.
Setting the spectrum analyzer display
There are two stored spectrum analyzer dis-
plays to select from.
1. Press ENT and then press S/A to select
the spectrum analyzer mode.
2. Press S/A1 or S/A2 to select the desired
spectrum analyzer.
Note:
• The spectrum analyzer display will disappear tem-
porarily when you perform other operations, but will
be displayed again after three seconds.
Setting the background visual
The background visuals are only for display
form 1 “FORM 1”. There are five stored back-
ground visuals to select from.
• When you select “FORM 2”, “BG” is not dis-
played and this mode is inactive.