Filter
Top Products
Audio Adjustments
3. Turn the ignition switch to ON or ACC.
If the car’s air conditioner or heater is turned
on, turn it off. Noise from the fan in the air
conditioner or heater may prevent correct
auto-equalizing.
• Press (up or down) SOURCE to turn the
source on if this product is turned off.
4. Select the position for the seat on which
the microphone is placed.
Refer to “Using position selector” on page
34.
• If no position is selected before you start
auto-equalizing, “FL” is selected automati-
cally.
5. Press (up or down) SOURCE to turn the
source off.
6. Press and hold 2 to enter the auto-
equalizer measurement mode.
The front panel opens automatically.
• When the source is off, you can check the
location of “ 2” by turnig on the feature
demo.
• You can also enter the auto-equalizer
measurement mode by pressing and hold-
ing AUDIO on the remote controller.
7. Plug the microphone into the microphone
input jack on this product.
8. Press A.EQ to start the auto-equalizing.
9. Get out of the car and close the door
within 10 seconds when the 10-second
count-down starts.
The measurement tone (noise) is output
from the speakers, and auto-equalizing
(acoustic characteristics measurement and
compensation) begins.
• When all speakers are connected, auto-
equalizing is completed in about four min-
utes.
• To cancel auto-equalizing part way
through, press any button.
10.When auto-equalizing is completed,
“Complete” is displayed.
When correct measurement of car interior
acoustic characteristics is not possible, an
error message is displayed. (Refer to
“Understanding auto-equalizing error mes-
sages” on page 48.)
11.Press any button to cancel the auto-
equalizer mode.
12.Store the microphone carefully in the
glove compartment.
Store the microphone carefully in the glove
compartment or other safe place. If the
microphone is subjected to direct sunlight for
an extended period, high temperatures may
cause distortion, color change or malfunc-
tion.
39