Pioneer DEH-24UB CD Player User Manual


 
Selecting asource
1 Press SRC/OFF tocycle between:
TUNER (tuner)CD(built-in CD player)USB
(USB)/iPod (iPod)AUX (AUX)
Adjusting thevolume
1 TurnM.C. to adjust thevolume.
CAUTION
For safety reasons, park your vehicle when re-
moving the front panel.
Note
When this units blue/white lead is connected to
the vehicles auto-antenna relay control termi-
nal, the vehicles antenna extends when this
units source is turned on. Toretract the anten-
na, turn the source off.
Use and care of the remote
control
Using theremote control
1 Point theremote control in thedirection of the
front panelto operate.
When usingfor the first time,pull out thefilm
protruding fromthe tray.
Replacing thebattery
1 Slide the tray outon the backof the remote
control.
2 Insert the battery with theplus (+) and minus
() polesaligned properly.
WARNING
! Keep the battery out of the reach of children.
Should the battery be swallowed, consult a
doctor immediately.
! Batteries (battery pack or batteries installed)
must not be exposed to excessive heat such
as sunshine, fire or the like.
CAUTION
! Use one CR2025 (3V) lithium battery.
! Remove the battery if the remote control is
not used for a month or longer.
! There is a danger of explosion if the battery is
incorrectly replaced. Replace only with the
same or equivalent type.
! Do not handle the battery with metallic tools.
! Do not store the battery with metallic ob-
jects.
! If the battery leaks, wipe the remote control
completely clean and install a new battery.
! When disposing of used batteries, comply
with governmental regulations or environ-
mental public institutions rules that apply in
your country/area.
! Perchlorate Material special handling may
apply.
See
www.dtsc.ca.gov/hazardouswaste/
perchlorate. (Applicable to California,
U.S.A.)
Important
! Do not store the remote control in high tem-
peratures or direct sunlight.
! The remote control may not function properly
in direct sunlight.
! Do not let the remote control fall onto the
floor, where it may becomejammed under
the brake or accelerator pedal.
Menu operations identical
for set up menu/function
settings/audio adjustments/
initial settings/lists
Returning tothe previous display
Returning tothe previous list(the folder one level
higher)
1 Press
.
Returning tothe ordinary display
Canceling theinitial setting menu/set upmenu
1 Press BAND/
.
Returning tothe ordinary display from thelist
1 Press BAND/
.
Tuner
Basic operations
Selecting aband
1 Press BAND/
until thedesired band (F1, F2,
F3 forFM or AM) isdisplayed.
Recalling presetstations
1 Press c ord.
! If MAN(manual tuning) is selectedin SEEK,
you cannotrecall preset stations. You needto
select PCH(preset channel) in SEEK. For de-
tails aboutthe settings, refer toSEEK (left/right
key setting) onthe next page.
Manual tuning(step by step)
1 Press c ord.
! If PCH(preset channel) is selectedin SEEK,
you cannottune up or downmanually. You
need toselect MAN (manual tuning)in SEEK.
Fordetails about the settings,refer to SEEK
(left/right key setting)on the nextpage.
Seeking
1 Press and holdc or d,and then release.
You can cancelseek tuning by brieflypressing
c ord.
While pressingand holding c ord, you can
skip stations.Seek tuning starts assoon as
you releasec or d.
Storing and recalling stations
for each band
Using preset tuning buttons
1 When you find a station that you want
to store in memory, pressone of the preset
tuning buttons (1 to 6) and hold until the
preset number stops flashing.
2 Press one of the presettuning buttons (1
to 6) to select the desired station.
Switching the display
Selecting thedesired text information
1 Press
.
Programservice name/frequencysong title/
artist nameentertainmentfrequency
! Depending onthe band, text informationcan
be changed.
! Text information itemsthat can bechanged
depend onthe area.
Function settings
1 Press M.C. to display the main menu.
English
Operating this unit
5
Section
Operating this unit
En
02