Filter
Top Products
51
50
Select the Output Mode you wish to test.
There are two modes to test your speaker settings: Manual and Auto
Manual Mode:
Once you have selected the appropriate Output Mode, click on any of the desired
speakers to verify proper connection. You can check the Loop Sounds box that will
result in continuous sound in that speaker. Click the Stop button to stop
the test.
Auto Mode:
Click on Auto Mode. Sounds will emanate in sequence starting with LF and cycle
through each speaker in the Output Mode you selected.
Use the Master Volume Slider to adjust the overall output level of your
speaker system.
Adjust speaker connections as required to complete your sound card installation.
S
PEAKER TEST TAB
The speaker test tab is a utility to help verify proper speaker connections to your
sound card. The acronyms are defined as follows:
• LF – Left Front Speaker
• RF – Right Front Speaker
• RS – Right Surround Speaker
• LS – Left Surround Speaker
• LHP – Left Headphone
• RHP – Right Headphone
Control Panel
703_rhythmic_usermanual.qxd 3/12/01 10:30 AM Page 50