Filter
Top Products
26
English
3139 115 20742
Timer Setting
The system can switch on to CD, TUNER, or
TAPE mode automatically at a preset time,
serving as an alarm to wake you up.
IMPORTANT!
– Before setting the timer, ensure that the
clock is set correctly.
– The timer will always be switched on
after it has been set.
– The timer will not start if a recording is in
progress.
– The volume of the timer will increase
gradually from the minimum level to the
last tuned volume level.
1 Press and hold TIMER on the remote control
for more than two seconds.
➜ "AM 12:00" or "00:00" or the last timer
setting will start flashing.
➜ TIMER will start flashing.
➜ The selected source will be lighted while
other available sources are flashing.
2 Press CD 1•2•3, TUNER or TAPE to select
the desired source.
● Before setting the timer, make sure the music
source has been prepared.
CD 1•2•3 – Load the disc(s). To start from a
specific track, make a programme (refer to “CD
Operation - Programming the disc tracks”).
TUNER – tune to the desired radio station.
TAPE – load a prerecorded tape.
3 Press à or á on the system repeatedly to set
the hour for the timer to start.
4 Press í or ë on the system repeatedly to set
the minute for the timer to start.
5 Press TIMER to store the start time.
➜ "TIMER ON" will be displayed and followed
by the set timer "XX:XX" and then the selected
source.
➜ TIMER will remain on the display.
● At the preset time, the selected source will play.
To exit without storing the setting
● Press Çon the system.
Notes:
– If CD is the selected source and it is not
available when the preset time is reached, Tuner
will be selected automatically.
– During timer setting, if no key is pressed within
90 seconds, the system will exit timer setting mode
automatically.
To check the TIMER
● Press TIMER on the remote control.
➜ If the timer has been activated, the set timer
information will be displayed.
➜ If the timer has been deactivated, "OFF" will
be displayed.
To activate/deactivate the TIMER
● Press TIMER ON/OFF repeatedly on the
remote control.
➜ If activated, the last set timer information will
be shown for a few seconds and TIMER will
appear on the display.
➜ If deactivated, “OFF” will be displayed.
Sleep Timer Setting
The sleep timer enables the system to switch to
Standby mode automatically within a preset
amount of time.
1 Press SLEEP on the remote control repeatedly
to select a preset amount of time.
➜ The selections are as follows (time in
minutes):
15 ™ 30 ™ 45 ™ 60 ™ OFF ™ 15 …
➜ "SLEEP XX" or "OFF" will be displayed.
"XX" is the time in minutes.
2 When you reach the desired length of time, stop
pressing the SLEEP button.
➜ SLEEP will appear on the display, except for
"OFF" mode.
➜ The Sleep Timer is now set. Before the
system switches to standby mode, a countdown
of 10 seconds will be displayed.
"SLEEP 10" ™ "SLEEP 9".... ™
"SLEEP 1" ™ "SLEEP"
While SLEEP mode is activated
To check the remaining length of time
● Press SLEEP once.
To change the preset sleep timer
● Press SLEEP twice.
➜ The display will show the remaining time
followed by the sequence of sleep timer options.
To deactivate the Sleep Timer
● Press SLEEP repeatedly until "OFF" is
displayed, or press the STANDBY ON button.
Clock/Timer
pg 001-029/MC50-70/22-Eng 3/7/01, 2:23 PM26