Filter
Top Products
20
English
3139 115 20742
Tuning to a weak radio station
● Press à or á briefly and repeatedly until the
optimal reception is found.
To stop storing the manual preset
● Press Ç on the system.
Notes:
– If you attempt to store more than 40 preset
radio stations, "PROGRAM FULL" will be
displayed.
– During programming, if no key is pressed within
20 seconds, the system will exit the Programme
mode automatically.
Tuning to Preset Radio Stations
● Once you’ve preset the radio stations, press í
or ë to select the desired preset number.
➜ The preset number, radio frequency, and
waveband will appear on the display.
Erasing a Preset Radio Station
1 Press í or ë to select the preset radio station
to be erased.
2 Press and hold Çon the system until “PRESET
DELETED” appears on the display.
➜ The radio frequency remain on the display.
➜ The preset numbers of all other preset radio
stations in the band with higher numbers are
also decreased by one.
● Repeat steps 1–2 to erase other preset radio
stations.
For Recording, please refer to “Tape
Operation/Recording”.
Radio Reception
RDS
RDS (Radio Data System) is a broadcasting
service that allows FM stations to send additional
information along with the regular FM radio
signal. This additional information can contain:
STATION NAME: The radio station name is
displayed.
PROGRAMME TYPE: The following
programme types exist and can be received by
your tuner: News, Affairs, Info, Sport, Educate,
Drama, Culture, Science, Varied, Pop M, Rock M,
M.O.R. (middle of the road music), Light M,
Classics, Other M, No type.
RADIO TEXT (RT): text messages appear on
the display.
Receiving RDS Radio Station
● Tuned to a radio station from FM band.
➜ If the radio station transmitting RDS signal,
the RDS logo ( ) and the radio station
name will appear on the display.
To check the RDS information
● Press RDS on the remote control repeatedly to
scroll through the following information (if
available) : STATION NAME ™ PROGRAMME
TYPE ™ RADIO TEXT ™ TUNED FREQUENCY
™ STATION NAME ....
Notes:
– If the tuned radio station does not transmit RDS
signal or is a non RDS station, "NO RDS" will be
displayed.
– If the RDS text message is not available at the
RDS station, "NO RDS TEXT" will be displayed.
RDS Time
Some RDS station may be transmitting a real
clock time at an interval of every minute.
Setting the RDS time
1 Press and hold CLOCK on the remote control.
➜ "00:00" or current time starts flashing.
2 Press RDS on the remote control.
➜ "SEARCH RDS TIME" will be displayed.
➜ When RDS time is read, "RDS TIME" will
be displayed. The current time will be displayed
for 2 seconds and stored automatically.
➜ If the RDS station does not transmit RDS
time within 90 seconds, "NO RDS TIME" will
be displayed.
pg 001-029/MC50-70/22-Eng 3/7/01, 2:23 PM20