Filter
Top Products
25
English
3139 115 20742
Clock/Timer
IMPORTANT!
When in Eco Power Standby mode, it is not
possible to operate the clock or timer
function.
Clock Setting
The clock can be set in either 12-hour or
24-hour mode ("AM 12:00" or "00:00" for
example)
1 Press and hold CLOCK on the remote control
until the time flashing on the display.
2 Press PROG on the system repeatedly to select
clock mode.
➜ If 12-hour mode is selected, "AM XX:XX"
will start flashing.
➜ If 24-hour mode is selected, "XX:XX" will
start flashing.
3 Press à or á on the system repeatedly to set
the hour.
4 Press í or ë on the system repeatedly to set
the minute.
5 Press CLOCK again to store the setting.
➜ The clock will start working.
To exit without storing the setting
● Press Çon the system.
Notes:
– The clock setting will be cancelled when the
power cord is disconnected or if a power failure
occurs.
– During clock setting, if no key is pressed within
90 seconds, the system will exit clock setting mode
automatically.
– To set the clock automatically through the time
information in the RDS signal, refer to "Radio
Reception - RDS Time".
Display Clock
The system allows you to select clock display or
normal display in any source mode (except Eco
Power Standby mode). When in Standby mode,
the clock will automatically be displayed.
● Press CLOCK on the remote control
repeatedly to select clock display or normal
display mode.
➜ When in clock display mode, clock will be
displayed. If the clock has not been set, "--:--"
will appear on the display.
Note:
– If you pressed any keys during clock display
mode, the display will briefly show the information
related to the selected mode.
-
-+
-
OPEN
STANDBY
-
ON
ECO
POWER
iR
VOL
AUX/CDR
PROG
PRESET
TAPE
SEARCH/TUNE
TUNER
DEMO STOPPAUSE
PREV
NEXT
REC
STOP
PLAY
BASS TREBLE
NEWS
-+
CD 1•2•3
MICRO SYSTEM
pg 001-029/MC50-70/22-Eng 3/7/01, 2:23 PM25