Philips MC-70 Stereo System User Manual


 
22
English
3139 115 20742
Tape Operation/Recording
IMPORTANT!
Before playing a tape, check and tighten
slack tape with a pencil. Slack tape may get
jammed or may burst in the mechanism.
C-120 tape is extremely thin and is easily
deformed or damaged. It is not
recommended for use in this system.
Store the tapes at room temperature and
do not put them too close to a magnetic
field (for example, a transformer, TV or
speaker).
Tape Playback
1 Press TAPE to select tape mode.
2 Press # OPEN to open the tape deck door.
3 Insert a recorded tape and close the tape door.
Load the tape with the open side down and the
full spool to the left.
4 Press PLAYÉ (ÉÅ ) to start playback.
"TAPE" with playback direction indicator will
appear on the display.
To stop playback
Press Ç.
To change the playback side
Press í or ë.
The A (BACK) or B (FRONT) appear on
the display, depending on the tape side selected.
To change the playback mode
Press AUTO REV. on the remote control
repeatedly to select the different playback
modes.
å : playback on one side of the tape only.
: both sides are played once.
: both sides are played repeatedly, up
to 10 times each side unless you pressÇ.
To rewind or fast forward during
playback
Press and hold à or á until the desired
passage is reached, then release.
The tape continues playing.
The tape will stop automatically at the end of
the tape during rewinding or fast forwarding.
During searching, the sound is reduced to a
low volume.
To rewind or fast forward when playback
is stopped
1 Press à or á.
2 Press Ç when you reached the desired passage.
-
-+
-
OPEN
STANDBY
-
ON
ECO
POWER
iR
VOL
AUX/CDR
PROG
PRESET
TAPE
SEARCH/TUNE
TUNER
DEMO STOPPAUSE
PREV
NEXT
REC
STOP
PLAY
BASS TREBLE
NEWS
-+
CD 123
MICRO SYSTEM
pg 001-029/MC50-70/22-Eng 3/7/01, 2:23 PM22