Filter
Top Products
41
English
Troubleshooting
Problem
Solution
The DVD player does not start playback.
Cannot activate some features, such as
Angles, Subtitles, or multi-language
Audio.
There is no sound from the center and
surround speakers.
Radio reception is poor.
The remote control does not function
properly.
The timer is not working.
The display panel is dark.
Low hum or buzz sound.
– Insert a readable disc with the playback side
facing down. (see page 22)
– Check the disc type, color system and region
code. (see page 22)
– Check for any scratches or smudges on the disc.
– Press SYSTEM SETUP to turn off the setup
menu screen.
– Change the rating level. (see page 32)
– Moisture has condensed inside the system.
Remove the disc and leave the system turned
on for about an hour.
– The features may not be available on the DVD.
– Changing the language for the sound or
subtitle is prohibited on the DVD.
– Make sure the center and surround speakers
are connected correctly. (see page 11)
– Press SURROUND button to select a correct
surround sound setting. (see page 38)
– Make sure the source you are playing is
recorded or broadcast in surround sound
(DTS, Dolby Digital, etc.)
– If the signal is too weak, adjust the antenna or
connect an external antenna for better reception.
– Increase the distance between the system and
your TV or VCR.
– Tune in to the correct frequency.
– Place the antenna farther away from any
equipment that may be causing the noise.
– Select the source (DISC or TUNER, for
example) before pressing the function button
(ÉÅ, S, T.)
– Reduce the distance between the remote
control and the system.
– Replace the batteries with new ones.
– Point the remote control directly toward the
IR sensor.
– Check that the batteries are loaded correctly.
– Set the clock correctly. (see page 18)
– Press and hold CLOCK•TIMER to switch on
the timer. (see page 36)
– Press DIM again. (see page 39)
– Place the DVD system as far away as possible
from electrical devices that may be causing
interference.