Filter
Top Products
15
2 Ensure that the wired router is turned on
and has broadband Internet access.
3 Follow the steps in chapter First-time
connection to home network until
NP2500 shows the prompt for the
network setup.
4 Select [Wired (Ethernet)] to start the
network setup process.
NP2500 acquires the automatic IP »
address.
NP2500 shows the conrmation for »
the connection to the network.
NP2500 shows the prompt for the »
connection to the Internet.
5 Select [Yes] to connect to the Internet.
NP2500 shows the conrmation for »
the connection to the Internet.
First-time setup: Wired connection
with static IP address
This is how to navigate and select with the
remote control:
Press •
or to select a menu option.
Press • OK to conrm a selection.
Press • BACK
to go back to the
previous screen.
Press • HOME to go to the Home menu.
The alphanumeric buttons of the remote
control are multi-function buttons:
To select a number or an alphanumeric •
character, press a button once or
repeatedly until you see the number or
alphabetic character in the display of
NP2500.
To cycle through the alphanumeric •
characters that are available, press a
button repeatedly.
To delete the last character entry from •
the display, press CLEAR.
To delete the whole last line entry •
from the display, press and hold
CLEAR.
Note
You can enter more than one encryption key. •
In this case, NP2500 prompts you to select the
default encryption key.
First-time setup: Wired connection
with automatic IP address
This is how to navigate and select with the
remote control:
Press •
or to select a menu option.
Press • OK to conrm a selection.
Press • BACK
to go back to the
previous screen.
Press • HOME to go to the Home menu.
The alphanumeric buttons of the remote
control are multi-function buttons:
To select a number or an alphanumeric •
character, press a button once or
repeatedly until you see the number or
alphabetic character in the display of
NP2500.
To cycle through the alphanumeric •
characters that are available, press a
button repeatedly.
To delete the last character entry from •
the display, press CLEAR.
To delete the whole last line entry •
from the display, press and hold
CLEAR.
The onscreen display guides you
through the process of connecting
NP2500 to your home network
and the Internet. This section
describes the typical wired setup
with automatic IP address. You can
also follow the onscreen prompts for
advanced congurations that are not
described in this manual.
1 Connect an Ethernet cable (sold
separately) to the ETHERNET jack of
NP2500 and the Ethernet jack of the
wired router.
English
EN