Filter
Top Products
28
English
3139 115 20852
Clock/Timer
STANDBY
-
ON
PROGRAM DIM
VCD MP3-CD MINI HIFI SYSTEM
CD1 • 2 • 3 BAND
TAPE 1 • 2
TAPEVCD TUNER
AUX
STOP•CLEAR
PLAY• PAUSE
CDR/VIDEO
RECORD
DUBBING A.REPLAY
VOLUME
CLOCK•TIMER
RETURNPBC
DEMO STOP
PAL/NTSC
SEARCH•TUNING
PREV NEXT
PRESET
▲
▲
MP
3
-
CD
ALBUM
+
TITLE
+
MICROPHONE - LEVEL
D
B
B
JOG
CONTROL
V
E
C
D
S
C
T
E
C
H
N
O
R
O
C
K
J
A
Z
Z
O
P
T
I
M
A
L
INCREDIBLE
SURROUND
View Clock
You can view the clock (if it is set) if the system
is in Standby mode or when any sound source is
selected (VCD, TUNER, etc.). The clock will be
displayed for about seven seconds.
¶ Press CLOCK•TIMER briefly (on the system
only).
➜ “PM10:38 or 22:38” (the current time) will
be displayed depending on whether you have
selected 12- or 24-hour mode.
➜ “--:--” will be displayed if the clock is not
set.
Clock Setting
The clock can be set in either 12- or 24-hour
mode, e.g. “AM12:00“ or “00:00“. Before
setting the clock, you must be in the View Clock
mode.
1 Press CLOCK•TIMER to select clock mode.
2 Press PROGRAM to select 12- and 24- hour
mode.
➜ If 12-hour mode is selected, “AM12:00“
starts flashing.
➜ If 24-hour mode is selected, “00:00” starts
flashing.
3 Set the hour with à or á on the system.
4 Set the minute with í or ëon the system.
5 Press CLOCK•TIMER again to store the
setting.
➜ The clock starts.
¶ To exit without storing the setting, press Ç on
the system.
Notes:
– During clock setting, if no button is pressed
within 90 seconds, the system will exit clock setting
mode automatically.
– When a power interruption occurs, the clock
setting is erased.
Timer Setting
¶ The system can switch on to VCD , TUNER or
TAPE 2 mode automatically at a preset time. It
can serve as an alarm to wake you up.
¶ Before setting the timer, make sure the clock is
set correctly.
¶ The timer will always be switched on once it is
set.
¶ The volume of the timer will increase
from the minimum level to the most
recently selected volume level.
1 Press and hold CLOCK•TIMER for more than
two seconds to select timer mode.
➜ “AM12:00” or “00:00" or the last timer
setting starts flashing depending on whether you
have selected 12- or 24-hour mode.
➜ The TIMER starts flashing.
➜ The selected source is lit while other available
sources are flashing.
2 Press VCD , TUNER or TAPE to select the
desired source.
¶ Before selecting VCD or TAPE, make sure a disc
or tape is loaded in the disc tray or tape deck 2.
pg 01-32/V320/21-Eng 28/05/2001, 09:02 AM28