Filter
Top Products
9
English
3139 115 20823
Preparation
Controls (main system’s illustration on page 3)
E Video Out Connection
Connect the VIDEO OUT terminal at the rear of
the system to the TV or VCR VIDEO IN for
viewing or recording.
F Adjusting the Operating Voltage
Before connecting the AC power cord to the
wall outlet, make sure that the voltage selector at
the rear of the system is set to the local power
line voltage. If not, reset the selector before
connecting to the wall outlet.
G AC Power Supply
After all other connections have been made,
connect the AC power cord to the system and
to the wall outlet.
Inserting batteries into the
Remote Control
¶ Insert the batteries (Type R06 or AA) into the
remote control as shown in the battery
compartment.
CAUTION
– Remove batteries if they are exhausted
or not to be used for a long time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances, so
they should be disposed off properly.
Controls on the player and
remote control
1 STANDBY-ON y
– switches the system to standby/on.
2 DBB (DYNAMIC BASS BOOST)
– to switch on bass boost to enhance bass
response or to switch off bass boost.
3 DIGITAL SOUND CONTROL PANEL
– to view the desired DSC display.
4 DSC (DIGITAL SOUND CONTROL)
– to select the desired sound effect :
OPTIMAL, JAZZ, ROCK or TECHNO.
5 PROGRAM
for VCD/CD/MP3-CD…to programme disc
tracks.
for TUNER ........to programme preset radio
stations.
for CLOCK.......to select 12 or 24 hour in clock
setting mode
.
6 MICROPHONE
– to connect microphone jack.
7 MIC LEVEL
– to adjust the mixing level for karaoke or
microphone recording.
8 RECORD
– to start recording on tape deck 2.
9 DUBBING
– to dub a tape in normal speed.
0 DISPLAY SCREEN
– to view the current setting of the system.
! CD CHANGER TRAY
@ DISC CHANGE
– to change disc(s).
# OPEN•CLOSE
– to open or close the CD changer tray.
$ DISC 1 / DISC 2 / DISC 3 (DISC DIRECT
PLAY)
– to select a disc tray for playback.
% SOURCE – to select the following:
VCD / (CD 1•2•3)
– to select VCD/CD mode (this system can
playback MP3-CD format disc also). When VCD/
CD playback is stopped, press to select the disc
tray 1, 2 or 3.
PAL / NTSC
– to select corresponding PAL or NTSC system of
your TV set (exception Multi-system TV).
pg 01-032/V220/21-Eng 28/05/2001, 09:03 AM9