Filter
Top Products
36
English
Manual preset programming
1 Press TUNER (BAND) repeatedly to select the
desired tuner band: FM or MW.
2 Press and hold 1 / ¡ on the system or on
the remote control to search a radio frequency.
3 Press PROGRAM.
➜ “PROG” and “01” will display.
4 Press O / P or numeric keys (0-9) to
select the desired preset number.
5 After selecting an address number, press
PROGRAM again to store the radio station.
● Repeat steps 3-5 to store other preset radio
stations.
To stop storing the manual preset
● Press 7 on the system.
Note:
– If you attempt to store more than 40 preset
radio stations, “FULL” will be displayed.
Selecting a preset radio station
● In tuner mode, press O / P or use the
numeric keys (0-9) to select the desired
preset number.
➜ The preset number, radio frequency, and
waveband are displayed.
Deleting a preset radio station
1 Press O or P to select the preset radio station
to be erased.
2 Press 7 on the system, “PRESET DELETED”
appears on the display.
➜ The preset numbers of all other preset radio
stations in the band with higher numbers are
also decreased by one.
● Repeat steps 1-2 to erase other preset radio
stations.
Changing tuning grid
In some countries, the frequency step between
adjacent channels in the MW band is 9 kHz (10
kHz in some areas). The preset frequency step in
the factory is 9 kHz.
1 Plug the AC power cord.
2 Press TUNER to select MW mode.
3 Press and hold 9 for more than 3 seconds.
➜ “STEP XX K” appears.
Note:
– All preset stations will be lost and need to be
reprogrammed.
Tuner Operations
p001-p047-FWD39-21_Eng 3/10/05, 09:0336