Filter
Top Products
23EN
• Before you press any function button, rst
select the correct source with the remote
control instead of the main unit.
• Reduce the distance between the remote
control and the unit.
• Insert the batteries with its polarities (+/–
signs) aligned as indicated.
• Replace the batteries.
• Aim the remote control directly at the
sensor on the front of the unit.
No disc detected
• Insert a disc.
• Check if the disc is inserted upside down.
• Wait until the moisture condensation at
the lens has cleared.
• Replace or clean the disc.
• Use a nalized CD or correct format disc.
Cannot display some les in USB device
• The number of folders or les in the USB
device has exceeded a certain limit. This
phenomenon is not a malfunction.
• The formats of these les are not
supported.
USB device not supported
• The USB device is incompatible with the
unit. Try another one.
Poor radio reception
• Increase the distance between the unit and
your TV or VCR.
• Fully extend the FM antenna.
• Connect an outdoor FM antenna instead.
Timer does not work
• Set the clock correctly.
• Switch on the timer.
Clock/timer setting erased
• Power has been interrupted or the power
cord has been disconnected.
• Reset the clock/timer.
Music playback unavailable after successful
connection
• The Bluetooth-enabled device is
incompatible with the unit.
Bluetooth-enabled device connection error
• The device does not support the proles
required for the unit.
• The unit already connected with another
Bluetooth-enabled device. Disconnect that
device or all other connected devices and
then try again.
The paired mobile phone connects and
disconnects constantly
• The Bluetooth reception is poor. Move the
mobile phone closer to the unit or remove
any obstacle between the mobile phone
and the unit.
• Some mobile phones may connect and
disconnect constantly when you make
or end calls. This does not indicate any
malfunction of the unit.
• For some mobile phones, the Bluetooth
connection may be deactivated
automatically as a power-saving feature.
This does not indicate any malfunction of
the unit.