Filter
Top Products
9EN
Prepare the remote control
Caution
• Risk of explosion! Keep batteries away from heat,
sunshine, or re. Never discard batteries in re.
To insert the remote control battery:
1 Open the battery compartment.
2 Insert 2 AAA batteries with correct
polarity (+/-) as indicated.
3 Close the battery compartment.
Note
• If you are not going to use the remote control for a
long time, remove the batteries.
• Do not use old and new or different types of batteries
in combination.
• Batteries contain chemical substances, so they should
be disposed of properly.
a
b
c
Set clock
Note
• You can set the clock in the standby mode only.
1 In standby mode, press and hold PROG/
CLOCK SET to activate the clock setting
mode.
» SET CLOCK is displayed.
» The 12 hour or 24 hour format is
displayed.
2 Press / to select 12 hour or 24 hour
format.
3 Press PROG/CLOCK SET.
» The hour digits begin to blink.
4 Press / to set the hour.
5 Press PROG/CLOCK SET.
» The minute digits begin to blink.
6 Press / to set the minute.
7 Press PROG/CLOCK SET to conrm.
Turn on
1 Press .
» The unit switches to the last selected
source.
Switch to standby
1 Press to switch the system to standby
mode.
» The backlight on the display panel is
reduced.
» The clock (if set) is displayed on the
display panel.
To switch the system to Eco Power standby
mode:
1 In standby mode, press and hold for
more than 2 seconds.
» ECO POWER is displayed.
» The backlight on the display panel
turns off.