Filter
Top Products
Paintin
g
ZxA5 S
p
eake
r
S
y
stems
Painting a ZxA5 Enclosure
The ZxA5 Loudspeaker Enclosures are made of a high performance Polypropylene material. For
best paint adhesion, we recommend a “Plastic Adhesion Promoter” be applied before any paint.
Sherwin Williams Plastic Adhesion Promoter UP07226 is a good example (See Telex document
number LIT000066-000 for further details.) Once Plastic Adhesion Promoter is applied follow the
manufacturer’s painting directions as you would normally.
Painting a ZxA5 Grille
Remove grille from loudspeaker and remove the backing material & logo from grille prior to painting.
Once the paint is dry, reapply the backing material and logo to the grille. Spray adhesive such as
3M Super 77 may help adhere the backing material to the grille.
Additional Precautions to be
T
aken
Prior to painting, be sure to take precautions not to get paint into the transducers. This can be
done by masking the grille, temporarily removing the grille and masking the transducers, or by
temporarily removing the grille and temporarily removing the transducers. Precautions must also
be taken not to get paint into any exposed electrical components by masking them off prior to
painting. It is also recommended that any exposed rigging points, warning labels, or instruction
labels be masked off for ease of future operation.
Ri
gg
in
g
P
oints Masked
Grille Masked
ZxA5 Enclosure
WARNING: It is critical to the system’s operation
that all transducers and exposed electrical
components be masked off prior to painting.
Painting
V
iew:
Paintin
g
the ZxA5 Enclosure
ELECTRO-VOICE
®
ZxA5 Owne
r
’
s Manual
18