Pelco NET104A Satellite Radio User Manual


 
C2900M-QS (9/02) 9
8. Change the field labeled Flow control to None. Click OK.
9. You are now ready to configure PelcoNet. Hold the Shift key and press the ? key. This brings up
the Help menu.
10. Press the I key to set the IP address. Type the new IP address PelcoNet will be using on the
network. Press Enter.
11. Press the S key to set the subnet mask. Type the new subnet mask. Press Enter.
12. Press the G key to set the gateway IP address. Type the new gateway IP address. Press Enter.
7
8
10
11
12
9
13. Close HyperTerminal. If prompted to save settings, click OK.