Filter
Top Products
6 C2900M-QS (9/02)
2. Click the Start button on the desktop, and select Programs from the Start menu.
STEP 2
CONFIGURING PELCONET USING HYPERTERMINAL
NOTE: If you do not want to configure PelcoNet using HyperTerminal, refer to the PelcoNet manual
for instructions on configuring PelcoNet using a web browser.
All commands consist of single characters you type inside the terminal window. Enter just one
command at a time. (Refer to the Terminal Command Reference table in the PelcoNet manual for
commands.)
1. Connect the D-sub COM jack on the NET104A to a free serial port on the PC. (Ensure the PC’s
COM port is set up properly [default parameters are 19200 baud, 8N1] and that the local
terminal echo is disabled.)