Filter
Top Products
IMPORTANT SAFETY INSTRUCTIONS
WARNING: When using electric products. basic cautions should always be followed, including the following.
I. Read all safety and operatin
g
instructions before
using
this product.
7
&.
All safety and operating instructions should be rctaincd for future rcfcrcncc.
3.
Obey all cautions in
the
operating instructions and on the back of the unit
4.
All operating instructions should be t’ollowcd.
5
_
This product should not be used near water, i.e.,
a bathtub, sink, swimming pool. wet
basement,
etc
6.
This product should be located
so
that its position does not interfere with its proper ventilation. It should not
bc
placed flat against a
wall or placed in a built-in enclosure that will impede the flow of cooling air.
I.
This product should not be placed near a source of heat
such
as a stove. radiator, or another heat producing amplifier.
8.
Connect only to a power supply of the type marked on
the
unit adjacent to the
power
s~~pply
cord.
9.
Never break off the ground pin on the power supply cord. For more information on
groundin,,
~7
write for our free
hooklct
“Shock
HaLard and Grounding.”
IO.
Power supply cords should always be handled carefully. Never walk or place equipment on power
s~~pply
cot&.
Pet-iodically check
cords for cuts or signs of stress. c~pecially at the plug and the point where the cord exits the unit.
I I, The power supply cord should be unplu
pged
when the unit is to he unused for long periods of time.
12.
If this product is to be mounted in an equipment rack, rear support should be provided.
13.
Metal parts can be cleaned with a damp rag. The vinyl covering used on some units can be cleaned with a damp
rag
or an
ammoni;~-
based household cleaner if necessary. Disconnect unit from power supply before cleaning.
14.
Care
should be taken so that objects do not
fall
and liquids are not spilled into the unit through
the
ventilation
holes
or any other
openings.
IS.
This unit should
be
checked by a qualified service technician if:
a.
The power supply cord or plug has been
damaged.
b.
Anything has fallen or been spilled into the unit.
c.
The unit does not opcratc correctly.
d.
The unit has been dropped or the enclosure damaged.
16.
The user should not attempt to service this equipment. All service work should
be
done by a qualified scrvicc technician
17.
This product should be used only with a cart or stand that is recommended by Peavey Electronics.
IX.
Exposure to extremely high noise lcvcls may
cause
a permanent hearing
loss.
Individuals
vary considerably in
\ujceptibility
to
noijc
induced hearing loss, but nearly everyone will lose some hearing if exposed to sufficiently intense noise for a sufficient time.
The U.S. Government’s Occupational Safety and Health
Administration
(OSHA) has specified the following
pcrmi\sihlc
noi\c
Icvcl
exposures.
Duration Per Day In Hours
Sound Lebel
dBA,
Slow Response
x
90
6
Y2
3
YS
3
Yl
2
100
I
II2
102
I
I
OS
l/2
I
IO
I
/4
or less
11s
According to OSHA, any exposure in excess of
the
above permissible limits could result in
some
hearing
10~5.
Ear plugs or protectors in the ear canals or over the cars
mu$t
be worn when operating this amplification
\y{tcm
in
ordcl-
to prcvcnl
a
permanent hearing loss it’exposure is in
cxccss
of the
limits
as set forth above. To
ensure
against potentially
dangcrouj
cxposurc to high
sound preajure levels, it is recommended that all persons exposed to equipment capable of producing high sound
PI-C~WI-c
levels such
aj
this amplification system be protected by hearing protectors while this unit is in operation.
SAVE THESE INSTRUCTIONS!
Features and specifications subject to change without notice.
Peavey Electronics Corporation 711 A Street
/
Meridian, MS 39301
/
U.S.A.
/
(601) 483-5365 /Telex 504115
/
Fax 486-1278
01994
#80301955
Printed in U.S.A. 1
l/94