Filter
Top Products
12
Front Panel Operation
On-Off Button
Push once to turn on the A 31. When the A 31 is turned on the blue glow around the On-Off
button will be brighter, the red P badge will glow brighter and then the 3 channel indicators
will illuminate blue. Push again to turn off the A 31. The front panel On-Off button will be
disabled when the Turn On Options switch is set to Audio or 12V.
Whenever the A 31 is turned on, the soft blue glow behind its On-Off button will change
to red for a few seconds as its internal circuits stabilize. Then the red glow is replaced
by a brighter blue glow to indicate normal operation. If the glow remains red after turn on
or while the amp is playing, it indicates activation of the A 31’s protection circuits and no
sound will be heard from the speaker.
The A 31 protects itself from external conditions such as excessive heat, load impedance
that is too low, or a short-circuited speaker connection or wire. After you correct the fault,
the A 31 will resume operation. If the A 31 remains “in protection” after it has cooled down
and you’ve confirmed there are no external faults, it could indicate an internal problem.
Please contact Parasound’s Technical Service Department.
Channel Indicators
When all three blue channel indicators are lit, the A 31 is operating normally. If one or more
of the indicators do not light even though the amp is turned on there is a fault in your system.
In the case of a fault first check that there is no short circuit with your speaker wire or
speakers.
Hi Temp Indicator
This indicator is near the right side of the panel recess. It will glow red if any channel
overheats. The On-Off button will also glow red if the A 31 overheats. If such a condition
occurs you must provide for better ventilation around the amplifier or check speakers for
faulty operation that is causing the A 31 to over heat.