Filter
Top Products
8
● DIP Switch Setup
An eight-bit DIP switch is provided for system setups. The
initial setting is marked with an asterisk *.
Note: Be sure to turn off the headset in Step 1. Otherwise,
the channel group (refer to p. 7 “Channel Group
Selection”) will not be activated until you turn off and on
the power again.
1. Press the power button to turn off the headset.
2. Set the switches as follows.
SW#1: For selection of a radio frequency suitable for
the location
ON: Applies the US frequency to the headset.
OFF: Applies the Canadian frequency.
SW#2: OFF
SW#3: OFF
SW#4: OFF
SW#5: OFF
SW#6: This switch selects the mode of Tone Squelch
method.
ON: The audio is output detecting the Tone Squelch
signal from the Center Module.
OFF: The audio is output in disregard of the Tone
Squelch signal from the Center Module.
Note: Normally, set SW#6 to ON. Pay attention to high
level noise that may be output when set to OFF.
1
SW#
2
3
4
5
6
7
8
Location
Function
—
—
—
—
—
—
—
—
OFF*
Tone Squelch
Talk Lock Resumption
——
USA*
ON
ON*
ON
CANADA
OFF
OFF*
OFF*
OFF*
OFF*
OFF
OFF*
SW#7: While talking with a customer in the TALK lock
mode, you may need to contact store personnel in
the PAGE mode which interrupts the TALK mode.
This switch specifies the status of the interrupted
TALK lock mode after ending the PAGE mode.
ON: Resumes the TALK lock mode.
OFF: Releases the TALK lock mode.
SW#8: OFF