Filter
Top Products
20
VQT5F18
Reference
Troubleshooting guide
Before requesting service, please perform the
following checks.
If the problem remains unresolved, consult
your dealer for instructions.
∫ Unit does not respond to remote
control or unit’s buttons.
Disconnect the AC mains lead, wait 1 minute,
then reconnect the AC mains lead.
The following do not indicate a problem with
this unit:
– Regular disc rotating sounds.
– Image disturbance during search.
To return to the factory defaults.
¾ Select “Restore” in “Default” in the Setup
menu. (> 17)
To return all settings to the factory preset.
¾ Reset the unit as follows:
1 Turn the unit on.
2 Press [<] to open the disc tray.
3 Press and hold [∫] and [1/;] on the main
unit at the same time for more than
5 seconds.
You have forgotten your ratings password.
You want to cancel the ratings level.
¾ The ratings level returns to the factory defaults.
jRestore the default settings following the
steps described in “To return all settings to
the factory preset.”. (> above)
This unit does not recognize the USB
connection correctly.
¾ Disconnect and re-connect the USB cable. If
it still does not recognize the connection, turn
this unit off and on again.
¾ USB devices may not be recognized by this
unit when connected using the following :
ja USB hub
ja USB extension cable
¾ If you connect USB HDD to this unit, use the
USB cable that is supplied with the HDD.
The images from this unit do not appear on
the TV.
Picture is distorted.
Jittering occurs.
¾ The “Resolution” setting is incorrect or the
“TV System” setting of the unit and that of the
TV do not match.
jRestore the default settings following the
steps described in “To return all settings to
the factory preset.”. (> left)
¾ PAL discs cannot be correctly viewed on an
NTSC TV.
¾ If irregular colouring occurs on your TV, turn
the TV off for about 30 minutes.
If it persists, move the speakers further away
from the TV.
No sound.
Low volume.
Distorted sound.
Cannot hear the desired audio type.
¾ Depending on the connected equipment, the
sound may be distorted if this unit is
connected with an HDMI cable.
¾ The multi-channel audio from a device
connected to the TV is not output in it’s
original multi-channel form.
jIf the device has an optical audio output
terminal, connect the device to this unit’s
DIGITAL AUDIO IN terminal. (> 7)
No sound from the TV.
¾ If there is no sound from the equipment
connected to this unit’s DIGITAL AUDIO IN
terminal, please make sure that the optical
audio output of the equipment is set to PCM.
Do you have the latest firmware installed?
Panasonic is constantly improving the unit’s
firmware to ensure that our customers are
enjoying the latest technology. (> 19)
General operation
Picture
Sound
SC-XH385&333GSGA-VQT5F18_mst.book 20 ページ ２０１４年３月１０日 月曜日 午後２時０分