Filter
Top Products
16
VQT5F18
∫ 5.1ch Front Layout
When you place all the speakers in a row at the
front, adjust the settings to achieve optimum
effects.
A Centre speaker
B Subwoofer
C Front speakers
D Surround speakers
∫ Surround Mode
Set the surround effects. (> 14)
∫ Sound Mode
Set the sound effects. (> 13)
∫ Subwoofer Level
You can adjust the amount of bass. (> 13)
∫ Speaker
Press [OK] to show the following settings:
¾Speaker Level
Set the volume of each speaker.
¾Speaker Delay
For optimum listening with 5.1-channel sound,
all the speakers, except for the subwoofer,
should be the same distance from the seating
position.
If either distance 1 or 2 is less than 3,
measure the distance and adjust the time to
make up for the difference (see the table
below).
1 2 3: Primary listening distance
A Actual speaker position
B Ideal speaker position
Delay time for the Centre speaker
Subtract the distance 1 from 3
Delay time for the Surround speakers
Subtract the distance 2 from 3
¾Test Tone
Each speaker will output a test signal sound in
sequence.
∫ Delay Time
Synchronization between picture and sound is
corrected by adjusting the delay time of the audio
output.
∫ Dynamic Range
You can listen at low volumes but still hear
dialogue clearly.
∫ Whisper Mode
You can enhance the surround effect for low
volume sound. (Convenient for late night
viewing.)
∫ Karaoke Setup
Press [OK] to show the following settings:
¾Echo level
Add the echo effect for the audio of
microphone. (> 13)
¾Mic Volume
Adjust the microphone volume. (> 13)
L
R
C
LS
RS
SW
D C
AB
D
C
C D
C D
:
:
L
LS
R
SW
C
RS
C
RS
LS
2
3
A
B
1
Distance (Approx.) Setting
34 cm 1.0 ms
68 cm 2.0 ms
102 cm 3.0 ms
136 cm 4.0 ms
170 cm 5.0 ms
Distance (Approx.) Setting
170 cm 5.0 ms
340 cm 10.0 ms
510 cm 15.0 ms
SC-XH385&333GSGA-VQT5F18_mst.book 16 ページ ２０１４年３月１０日 月曜日 午後２時０分