Filter
Top Products
17
RQTX0221
Getting StartedPlaying DiscsOther OperationsReference
Preparation
≥To display the picture, turn on the TV and select the appropriate video
input mode.
≥Press [i, ` VOL] to adjust the volume to normal listening level.
≥Select “TEST TONE” from “SPEAKER SETTINGS” in AUDIO menu
(B 29).
(Effective when playing 5.1-channel sound or when “ÎPLII” lights.)
Adjusting the speaker output level manually
1
Enter test tone mode.
Test tone will be output to each channel in
the following order.
LEFT, CENTER, RIGHT,
SURROUND RIGHT, SURROUND LEFT
2
Adjust the speaker level for each
speaker. (CENTER, SURROUND
RIGHT, SURROUND LEFT)
`
6dB to
i
6 dB (Factory preset: 0 dB)
≥To exit the screen, press [SETUP].
To adjust speaker level during play
1 Press and hold [—CH SELECT] to select the speaker.
While the speaker channel is displayed, press [—CH SELECT].
L# C# R# RS# LS# SW
^----------------------------------------------}
≥You can adjust SW (Subwoofer) only if the disc includes a
subwoofer channel and “ÎPLII” is not lit.
≥“S” appears on the main unit’s display when you have selected
“S.SRND” (B 16, Enjoying surround sound effects). In this case,
you can adjust both surround speaker levels at the same time using
[3, 4].
S: `6dB to i6dB
2 Press [3] (increase) or [4] (decrease) to adjust the speaker level
for each speaker.
C, RS, LS, SW: `6dB to i6dB
(L, R: Only the balance is adjustable.)
To adjust the balance of the front speakers, while “L” or “R” is selected,
press [2, 1].
OK
e.g.
SET
RETURN
AUDIO-SPEAKER SETTINGS-TEST TONE
SPEAKER
LEFT
CENTER
RIGHT
SURROUND RIGHT
SURROUND LEFT
TRIM LEVEL
− −
0dB
− −
0dB
0dB
EXIT : SETUP
OK
RQTX0221-P_770_en.book Page 17 Monday, January 12, 2009 5:56 PM