Filter
Top Products
14
RQTX0221
Getting StartedPlaying DiscsOther OperationsReference
Setting up the radio (continued)
Up to 30 stations can be set in each band, FM and AM.
A station previously stored is overwritten when another station is stored in
the same channel preset.
FM frequency step
Main unit only
The step is factory-set to 0.2-MHz, but you can change it to receive
broadcasts allocated in 0.1-MHz steps. You may need to change this
setting if the tuner seems to skip over the correct frequency for stations in
your area.
1 Press [SELECTOR] to select “FM”.
2 Press and hold [SELECTOR].
After a few seconds the display changes to show the current minimum
frequency. Continue to hold the button down. The minimum frequency
changes and the step is changed.
e.g. 87.9 (Factory preset) ,# 87.5
To return to the original step, repeat steps 1 and 2.
[Note]
After changing the setting, previously preset frequencies will be cleared.
Preset them again.
1 2 3
4 5 6
7 8
0
9
10
OK
SKIP SKIP
Numbered
buttons
OK
,
VOLUME
SELECTOR
TUNE
MEMOR
Y
Presetting stations manually
1 While listening to the radio broadcast
Press [OK].
2 While the frequency is flashing on the display
Press the numbered buttons to select a channel.
≥To select a 2-digit number
e.g. 12: [S10] B [1] B [2]
Alternatively, press [X, W], and then press [OK].
Main unit:
1 While listening to the radio broadcast
Press [MEMORY] twice.
2 While a channel number is flashing on the display
Press [X TUNE W], and then press [MEMORY].
RQTX0221-P_770_en.book Page 14 Monday, January 12, 2009 5:56 PM