Filter
Top Products
9
Simple Setup
Cable connections / AC cord connection / Preparing the remote control
RQTX0094
Conserving power
The main unit consumes a small amount of power when it is turned off
(main unit: approx. 0.3 W). To save power when it is not to be used for a
long time, unplug it from the household AC outlet.
You will need to reset some memory items after plugging in the main
unit.
[Note]
The included AC power supply cord is for use with the main unit only.
Do not use it with other equipment. Also, do not use cords for other
equipment with the main unit.
∫ Batteries
≥Do not heat or expose to flame.
≥Do not leave the battery(ies) in an automobile exposed to direct
sunlight for a long period of time with doors and windows closed.
Do not:
≥mix old and new batteries.
≥use different types at the same time.
≥take apart or short circuit.
≥attempt to recharge alkaline or manganese batteries.
≥use batteries if the covering has been peeled off.
Mishandling of batteries can cause electrolyte leakage which can
severely damage the remote control.
Remove the batteries if the remote control is not going to be used for a
long period of time. Store in a cool, dark place.
∫ Use
Aim at the remote control signal sensor (➜ 13), avoiding obstacles,
at a maximum range of 7 m (23 ft) directly in front of the unit.
Using an FM/AM outdoor antenna (optional)
FM ANT
(75 )
AM ANT
EXT
LOOP
LOOP ANT GND
Leave the AM loop
antenna connected.
AM outdoor antenna
[Using a vinyl wire (not included)]
Run a piece of vinyl wire horizontally across a
window or other convenient location.
5.0 m to 12 m
(16 ft to 39 ft)
FM outdoor antenna
[Using a TV antenna (not included)]
≥The antenna should be installed by a
competent technician.
75 ≠ coaxial cable
§
(not included)
Antenna plug (not included)
Use outdoor antenna if FM/AM radio reception is poor.
≥Disconnect the antenna when the unit is not in use.
≥Do not use the outdoor antenna during an electrical storm.
1 Remove a piece of the outer
vinyl insulator.
2 Carefully pull the tabs apart
to remove the cover.
3 Install the coaxial cable.
Clamp the cable conductor, and
wind it on so that it does not
contact anything else.
7 mm (
9
/32z)
Peel back
4 Attach the cover.
Clamp with pliers
10 mm (
13
/32z)
§
Rework your outdoor antenna’s 75 ≠ coaxial cable as follows.
10 mm (
13
/32z)
Main unit
step
4
AC cord connection
AC IN
AC power supply cord
(included)
Main unit
To household AC outlet
(AC 120 V, 60 Hz)
step
5
Preparing the remote control
CAUTION
Danger of explosion if battery is incorrectly replaced. Replace only
with the same or equivalent type recommended by the manufacturer.
Dispose of used batteries according to the manufacturer’s instructions.
R6/LR6, AA
Insert so the poles (i and j) match those in the remote control.
SC-PT660-663P-PC_eng.book 9 ページ ２００７年１２月１１日 火曜日 午後６時２７分