11
Simple Setup
Cable connections / AC mains lead connection / Preparing the remote control
11
RQTX0088
Conserving power
The main unit consumes a small amount of power, even when it is in
standby mode (approx. 0.4 W). To save power when the unit is not to be
used for a long time, unplug it from the household AC mains socket.
You will need to reset some memory items after plugging in the main
unit.
[Note]
The included AC mains lead is for use with the main unit only. Do not use
it with other equipment. Also, do not use cords for other equipment with
the main unit.
∫ Batteries
≥Do not use rechargeable type batteries.
≥Do not heat or expose to flame.
≥Do not leave the battery(ies) in an automobile exposed to direct
sunlight for a long period of time with doors and windows closed.
Do not:
≥mix old and new batteries.
≥use different types at the same time.
≥take apart or short circuit.
≥attempt to recharge alkaline or manganese batteries.
≥use batteries if the covering has been peeled off.
Mishandling of batteries can cause electrolyte leakage which can
severely damage the remote control.
Remove the batteries if the remote control is not going to be used for a
long period of time. Store in a cool, dark place.
∫ Use
Aim at the remote control signal sensor (➜ 15), avoiding obstacles,
at a maximum range of 7 m directly in front of the unit.
Other audio connections
TV or external
equipment terminal
Cable required
(not included)
Main unit terminal Features
Optical digital audio cable
≥Do not bend sharply when
connecting.
[\\\\\OPTICAL\IN\\\\\\]
This unit can decode the surround signals received
through the set top box, digital broadcasting or satellite
broadcasts. Refer to your equipment’s operating
instructions for details. Only Dolby Digital and PCM can
be played with this connection.
≥After making this connection, make settings to suit the
type of audio from your digital equipment (➜ 32).
step
4
AC mains lead connection
OPTICAL OUT
OPTICAL
I
N
AC IN
110
127V 220
240V
VOLT ADJ
To household
mains socket
AC mains lead (included)
Main unit
Use a flat-head screwdriver to
move the voltage selector to the
appropriate position for the area
in which this system is used.
[PT465]
Before connecting the AC mains
lead
Set the voltage.
[Saudi[Arabia[and[Kuwait]
BE SURE TO READ THE CAUTION FOR THE AC
MAINS LEAD ON PAGE 4 BEFORE
CONNECTION.
step
5
Preparing the remote control
CAUTION
Danger of explosion if battery is incorrectly replaced. Replace only
with the same or equivalent type recommended by the manufacturer.
Dispose of used batteries according to the manufacturer’s instructions.
R6/LR6, AA
Insert so the poles (i and j) match those in the remote control.
PT465GC-GS-GCS-GCT-PT460GN_RQTX0088-B_eng.book Page 11 Thursday, December 13, 2007 9:04 AM