Filter
Top Products
Getting Started
7
RQTX1168
Quick Start Guide
Basic setup example
[COMPONENT\VIDEO\OUT]
This connection provides a much purer picture than the VIDEO OUT
terminal.
Connect the Component Video cable (not supplied) from the
COMPONENT VIDEO OUT terminal on the main unit to the
COMPONENT VIDEO IN terminal on your TV.
To enjoy progressive video
≥Connect to a progressive output compatible TV.
– Set “VIDEO OUT (I/P)” in VIDEO menu to “PROGRESSIVE” and then
follow the instructions on the menu screen (B 15).
≥Panasonic TVs with 576/50i·50p, 480/60i·60p input terminals are
progressive compatible. Consult the manufacturer if you have another
brand of TV.
≥Do not make the video connections through the VCR.
Due to copy guard protection, the picture may not be displayed properly.
≥Only one video connection is required. Choose one of the video
connections above depending on your TV.
[Note]
If you have various sound sources (such as Blu-ray player, DVD recorder,
VCR, etc.), connect them to the available inputs on the TV and the TV
output should then be connected to the AUX/TV terminal of the main unit.
Conserving power
The main unit consumes a small amount of power, even when it is in
standby mode (approx. 0.9 W). To save power when the unit is not to be
used for a long time, unplug it from the household mains socket.
You will need to reset some memory items after plugging in the main unit.
[Note]
The supplied AC mains lead is for use with the main unit only.
Do not use it with other equipment. Also, do not use cords for other
equipment with the main unit.
This unit will memorize the playback position when there is a power
failure.
After the power supply recovers, turn on your TV and the main unit.
Playback will resume from the point at which it was stopped.
[Note]
≥The resume playback timing may vary a few seconds.
≥This function may not work for files that do not have resume playback.
≥The position is cleared if the disc tray is opened or the USB device is
removed.
2
Radio antenna connections
Using an indoor antenna
Using an outdoor antenna
3
Audio and video connections
FM ANT
(75 )
Adhesive tape
Main unit (rear)
FM indoor antenna
(supplied)
Affix this end of the antenna
where reception is best.
FM ANT
(75 )
Use outdoor antenna if radio reception is poor.
≥Disconnect the antenna when the unit is not in use.
≥Do not use the outdoor antenna during an electrical storm.
Main unit
(rear)
75 ≠ coaxial
cable
(not supplied)
FM outdoor antenna
(Using a TV antenna
(not supplied))
The antenna should be
installed by a competent
technician.
P
B
COMPONENT VIDEO OUT
P
R
VIDEO
OUT
Y
AUX/TV
L
R
You can enjoy the audio from your TV, cable or satellite STB,
or your VCR through this home theater system by connecting
to the AUX/TV terminal.
Select “AUX/TV” as the source (B 9).
Refer to the operating
instructions for the TV,
cable or satellite STB,
or VCR for the settings
necessary to output its
audio from the AUDIO
OUT terminal to your
home theater system.
Audio cable
(not supplied)
Main unit (rear)
Video cable
(supplied)
TV
Other video connection
step 3 AC mains lead connection
Power failure resume
AC IN
VOLT
ADJ
110−127V 220−240V
BE SURE TO READ THE CAUTION FOR THE AC
MAINS LEAD ON PAGE 21 BEFORE CONNECTION.
For Saudi Arabia and Kuwait
Main unit (rear)
To household mains socket
AC mains lead (supplied)
Before connecting the AC mains lead
Set the voltage.
For Southeast Asia
Use a flat-head screwdriver to move the voltage
selector to the appropriate position for the area
in which this system is used.
RQTX1168-G_eng.book Page 7 Friday, April 23, 2010 4:28 PM