Filter
Top Products
7
RQTV0225
■
Fitting optional speaker stands (not included)
Ensure the stands meet these conditions before purchasing them.
Note the diameter and length of the screws and the distance between screws as shown in the diagram.
The stands must be able to support over 10 kg.
The stands must be stable even if the speakers
are in a high position.
•
•
STEP 1 Speaker setup
Speaker stand
(not
included)
5 mm, pitch 0.8 mm
Plate thickness plus
7 mm to 10 mm
Metal screw holes
For attaching to speaker stands
■
Attaching to a wall
You can attach the surround, center and front speakers to a wall.
Drive the screw (not included) into the wall Fit the speaker securely onto the screw(s) with the hole(s).
384 mm
Center speake
r
190 mm
Surround speake
r
Front speakers
Attach to a wall without the base
and stand.
Ø7.0 to 9.4 mm
4.0 to 6.0 mm
Wall or pillar
Ø4.0 mm
At least 30 mm
1 2
The wall or pillar on which the speakers are to be
attached should be capable of supporting 10 kg per
screw. Consult a qualified building contractor when
attaching the speakers to a wall. Improper attachment
may result in damage to the wall and speakers.
Note
TRANSMITTER
DIGITAL
PUSH PUSH
PUSH PUSH
Push!Push!
Digital transmitter cover
Set your sound free with Panasonic’s wireless
receiver and speaker systems
Attach the SH-FX65 digital transceiver for wireless surround sound.
You can also connect your portable audio equipment to the wireless
system.
For details, refer to the operating instructions for SH-FX65.
Wireless system connection
You can use the blunt end of a writing instrument
to push here until the cover pops out.
Remove the digital transmitter cover before installing any optional
Panasonic wireless accessory.
Replace the cover when the digital transmitter is not in use.•
Note
■
Reattach the speaker cable
1
2
Insert the
cable from
bottom.
Pull out the
cable through
the hole.
Leave about
80 mm
+: White
−: Blu
e
Push!
2
2
Other speaker setup options
SC-HT65 GN-En.indb 7 8/17/2007 4:20:01 PM