Filter
Top Products
12
RQTV0225
To cancel during setup
Message Solutions Pages
“INSERT MIC” Calibration microphone is not detected. Insert the microphone correctly.• 11
“CHECK CONNECTION TO
LS/RS SPEAKERS”
One or both surround speakers not detected. Check the connections.• 6
“CHECK CONNECTION TO
L/R SPEAKERS”
Check the front (L) and (R) connections.• 6
Troubleshooting for auto speaker setup
While performing auto speaker setup, errors may occur and the messages will blink or scroll on the display, depending on the
conditions. Press any button on the main unit or remote control to stop the setup.
After troubleshooting, press and hold to start the setup process again.
AUTO SETUP
Auto speaker setup may produce an unsatisfactory result with some speaker setups and configurations.
Auto speaker setup will not start if you have muted the speakers. Turn the muting off (
➡
page 20).
Auto speaker setup will not start if you have plugged in headphone. Unplug any headphone.
VIERA Link “HDAVI Control
TM
” (
➡
page 8) is disabled during auto speaker setup.
•
•
•
•
Note
Press any button on the main unit or remote control. “CANCELED” appears on the display.
“COMPLETE” appears on the display and all calibrations are saved.
[AUTO SPEAKER SETUP] indicator lights.
To exit, press and hold .
Disconnect the calibration microphone.
•
•
•
•
a) Press and hold .
[AUTO SPEAKER SETUP] indicator starts flashing.
“AUTO SETUP” appears on the display.
b) The unit checks that you have correctly
connected the calibration microphone.
c) The automatic setup starts with STEP 1, STEP 2,
and STEP 3 calibration as follows.
STEP 1 (DETECTION/DISTANCE)
STEP 2 (SIZE/FREQUENCY)
STEP 3 (LEVEL)
For your reference
Loud test tones are output from each speaker during the configuration.
During setup, operations may stop when there is an error message on the display.
Refer below for troubleshooting.
•
•
•
•
AUTO SETUP
AUTO SETUP
AUTO
SPEAKER SETUP
AUTO
SPEAKER SETUP
Auto speaker setup finishes.
Start performing auto
speaker setup.
STEP 4Auto speaker setup
Auto speaker setup
Perform auto speaker setup again if you have changed the speakers, speaker positions, or the layout of your listening environment.
Note
Depending on the speakers, room environment, and speaker placement, you may get different results for lowpass
filter frequency and other items even when you are using the same speakers. The results are based on small speaker
configuration.
(The calibration will give optimal result for “Distance”. Therefore, you are not able to check the setting in page 13 while auto speaker
setup is in use.)
Turn off all components before making any connections.
Peripheral equipment and cables sold separately
unless otherwise indicated.
To connect equipment, refer to the appropriate
operating instructions.
•
•
•
MUSIC MOVIE
SFC
-EFFECT
C.FOCUS
-LEVEL
TEST
OK
VOLUME
TV/AV
MUTING
VOLUME
TOP MENU
FUNCTIONS
DIRECT NAVIGATOR
SUB MENU/
PLAY LIST
RETURN
AUTO SETUP
1
2 3
7
0
8
9
10
4 5
6
>
=
u
q
g
h
%PL
SKIP
SLOW/SEARCH
STOP PAUSE PLAY
^
AV
SYSTE
M
RECEIVER
BD/DVR
DVD-
P
TUNER
BAND
TV
TV
OFF
t y
^
TUNER
DIRECT TUNING
i
-/--
SC-HT65 GN-En.indb 12 8/17/2007 4:20:12 PM