Filter
Top Products
11
RQTV0225
Auto speaker setup allows you to achieve a satisfactory listening environment easily with the use of the supplied calibration microphone
as a detector of sound signals. The unit will first perform automatic speaker detection, then checks and adjusts the following settings.
Process for auto speaker setup
Loud test tones are output from the speakers during setup, so keep children out of the room.
Auto speaker setup
INPUT SELECTOR
TUNE
MENU
RETURN
SETUP
SETUP MIC
VOLUME
ENTER
AUTO SPEAKER
SETUP
Checks which speakers you have connected. For manual setup, “Speaker size”,
➡
page 13.
•
DETECTION
DISTANCE
Checks the distance of each speaker from the listening position and adjusts the
timing of each channel. For manual setup, “Distance”,
➡
page 13.
•
SIZE Calibrates based on small speaker configuration.•
LEVEL
Makes any further corrections to the volume of each speaker and also to the
frequency response.
•
Connect the calibration
microphone to the [SETUP
MIC] jack on the front
panel.
Note
The calibration microphone is sensitive
to heat. Keep it away from direct
sunlight and do not place it on top of
the unit.
Placing of calibration
microphone.
Place on a flat surface at the seating area.
Set calibration microphone position at your
ear height.
Use a tripod for best results.
•
•
•
Turn on the unit.
Press .
The standby indicator goes off when you turn on the unit.
•
Calibration microphone
(included)
Before setup
Conduct the auto speaker setup in a quiet environment. A noisy background will give unsatisfactory results.
Put the subwoofer in position, switch it on, and sets its volume to the level you would normally use.
•
•
STEP 4Auto speaker setup
FREQUENCY
Sets the appropriate low frequency crossover for each channel according to the
speaker size. For manual setup, “Filter”,
➡
page 12.
The setting is based on the speaker bass reproduction range.
Also checks on “Level” setting to adjust for each speaker.
•
•
•
Turn off all components before making any connections.
Peripheral equipment and cables sold separately
unless otherwise indicated.
To connect equipment, refer to the appropriate
operating instructions.
•
•
•
SC-HT65 GN-En.indb 11 8/17/2007 4:20:10 PM