Filter
Top Products
Advanced
operations
39
VQT3X51
[BTT196] [BTT195]
It is possible to shorten the height of the front
speaker by directly connecting the speaker to the
base without using the stand.
Preparation
Detach the speaker cable from the stand.
1 Thread the detached cable through the
base.
2 Attach the speaker to the base and tighten
the screw (supplied) securely.
3 Connect the speaker cable to the speaker
and to the terminal of the main unit.
(> 11, 12)
∫ Reattaching the speaker cable
to the stand
[BTT196] [BTT195] Preventing from falling
Front speaker
Preventing from dropping
Front speaker, Surround speaker, Center speaker
1 Thread a string to the speaker.
≥ Use a string of less than ‰ 2.0 mm (
3
/32q),
which is capable of supporting over 10 kg
(22 lbs).
e.g., [BTT196] Front speaker
A String (not supplied)
B Rear of the speaker
2 Thread a string from the wall to the
speaker and tie tightly.
C Screw eye (not supplied)
D Wall
E Approx.150 mm (5
29
/32q)
F Less than 100 mm (3
15
/16q)
Front speaker assembly option
Straighten the
cable and run
through the
stand.
Pull out the
cable through
the hole.
Preventing the speakers
from falling or dropping
When mounted on a wall
When placed on the floor
SC-BTT190P_eng.book 39 ページ ２０１２年２月２０日 月曜日 午後５時５分