Filter
Top Products
- 31 -
The mode indicator (amber) keeps blinking twice.
≥ This unit is not connected to the network. Touch any switch, and then
check the network connection. (l 12)
The mode indicator (amber) keeps blinking three times.
≥ The update has been failed. Touch any switch, and then try again.
The mode indicator (amber) keeps blinking fast.
≥ An error has occurred. Disconnect the AC power supply cord (AC mains
lead) and reconnect it. Turn the unit on and try again.
The network indicator (red) keeps blinking.
≥ This unit is not connected to the network. Check the network
connection. (l 12)
Cannot connect to the network.
≥ This unit’s Wi-Fi security supports WPA2™ only. Use a wireless router
that provides a WPA2™ connection. For details on security supported
by the router, refer to the operating instructions of the router.
≥ If the network is set to be invisible, make the network visible while you
set up the network for this unit or make a wired LAN connection. (l 18)
≥ Make sure that the multicast function on the wireless router is enabled.
≥ Depending on the routers, WPS button may not work. Try other
methods. (l 12)
The device name is not changed.
≥ Turn off “Network standby” (l 16), and turn this unit off and on.
Firmware updates
Network