Filter
Top Products
Confidential
Until:
9 May 2014
8
RQT9899
Preparing media
Disc
1 Press [USB/CD] to select “CD”.
2 Press [CD x] (main unit: [x OPEN/CLOSE]) to open
the disc tray.
Put in a disc with the label facing up.
3 Press [CD x] (main unit: [x OPEN/CLOSE]) again to
close the disc tray.
USB
Preparation
Before you connect a USB device to the system, make
sure you do a backup of the data.
1 Lower the volume and connect the USB device to
the USB port.
Hold the main unit when connecting or disconnecting
the USB device.
2 Press [USB/CD] to select “USB A” or “USB B”.
Note:
Do not use a USB extension cable. The system cannot
recognize the USB device connected through a cable.
Bluetooth
®
You can connect and play an audio device wirelessly
through Bluetooth
®
.
Preparation
• Turn on the Bluetooth
®
feature of the device and put
the device near the system.
• Read the operating instructions of the device for
details.
█ Pairing a device
Preparation
If this system is connected to a Bluetooth
®
device,
disconnect it (Z“Disconnecting a device”).
1 Press [ ].
If “PAIRING” is shown, continue with step 4.
2 Press [PLAY MENU] to select “PAIRING”.
Or press and hold [ –PAIRING] on the main unit until
“PAIRING” is shown. Continue with step 4.
3 Press [R, T] to select “OK? YES” and then press
[OK].
“PAIRING” is shown.
To cancel, select “OK? NO”.
4 Select “SC-AKX18” from the Bluetooth
®
menu of the
device.
If prompted for a passkey, input “0000”.
The device connects with this system automatically
after pairing is complete.
The name of the connected device is shown for a
few seconds.
Note:
You can pair up to 8 devices with this system. If a 9th device
is paired, the device that has not been used for the longest
time will be replaced.
█ Connecting a device
Preparation
If this system is connected to a Bluetooth
®
device,
disconnect it (Z“Disconnecting a device”).
1 Press [ ].
“BLUETOOTH READY” is shown.
2 Select “SC-AKX18” from the Bluetooth
®
menu of the
device.
The name of the connected device is shown for a
few seconds.
3 Start playback on the device.
Note:
• A device must be paired to connect.
• The system can only connect to one device at a time.
• When “BLUETOOTH” is selected as the source, this
system will automatically try to connect to the last
connected device.
█ Disconnecting a device
1 Press [ ].
2 Press [PLAY MENU] to select “DISCONNECT?”.
3 Press [R, T] to select “OK? YES” and then press
[OK].
“BLUETOOTH READY” is shown.
To cancel, select “OK? NO”.
Using the main unit
Press and hold [ –PAIRING] until “PAIRING” is shown.
Note:
A device is disconnected when you:
• Select a different source.
• Move the device out of the maximum range.
• Disable the Bluetooth
®
transmission of the device.
• Turn off the system or the device.
D
J J
UKEBOX
D.BASS
A
B
USB device
(not supplied)
SC-AKX18 P RQT9899-P EN.fm Page 8 Monday, April 14, 2014 10:41 AM
printing