Filter
Top Products
Confidential
Until:
9 May 2014
12
RQT9899
Clock and timers
Setting the clock
This is a 12-hour clock.
1 Press [SETUP] to select “CLOCK”.
2 Press [R, T] to set the time and then press [OK].
To check the time
Press [SETUP] to select “CLOCK” and the press [OK].
In standby mode, press [DISPLAY].
Note:
Reset the clock regularly to maintain accuracy.
Sleep timer
The sleep timer turns off the system after the set time.
1 Press [SETUP] to select “SLEEP”.
2 Press [R, T] to select the setting (in minutes) and
then press [OK].
To cancel, select “OFF”.
Note:
• The remaining time is always shown on the display. The
display changes temporarily when you perform other
operations.
• The play and sleep timer can be used together.
• The sleep timer always comes first. Be sure not to set an
overlapping time.
Play timer
(Except for Bluetooth
®
source)
You can set the timer to come on at a certain time to
wake you up.
Preparation
Set the clock.
1 Press [SETUP] to select “TIMER ADJ”.
2 Press [R, T] to set the start time and then press
[OK].
3 Re-do step 2 to set the end time.
4 Press [R, T] to select the source you want to play
and then press [OK].
To start the timer
1 Press [SETUP] to select “TIMER SET”.
2 Press [R, T] to select “SET” and then press [OK].
“#” is shown.
To cancel, select “OFF”.
The system must be turned off for the timer to
operate.
To check the setting
Press [SETUP] to select “TIMER ADJ” and then press
[OK].
In standby mode, press [DISPLAY] two times.
Note:
• The timer starts at a low volume and increases gradually to
the preset level.
• The timer comes on at the set time every day.
• If you turn off the system and then turn on again while the
timer is in operation, the timer will not stop at the end time.
SC-AKX18 P RQT9899-P EN.fm Page 12 Monday, April 14, 2014 10:41 AM
printing