Filter
Top Products
Confidential
Until:
9 May 2014
13
RQT9899
External equipment
You can connect a VCR, DVD player etc., and listen to
the audio through this system.
Preparation
• Disconnect the AC power supply cord.
• Turn off all equipment and read the appropriate
operating instructions.
1 Connect the external equipment.
2 Press [RADIO/AUX] to select “AUX”.
3 Play the external equipment.
To adjust the input level
1 Press [SOUND] to select “INPUT LEVEL”.
2 Press [R, T] to select “NORMAL” or “HIGH” and
then press [OK].
Note:
• The default setting is “NORMAL”.
• Select “NORMAL” if the sound is distorted during “HIGH”
input level.
• Components and cables are sold separately.
• If you want to connect equipment other than those
mentioned, refer to the audio dealer.
• Sound distortion can occur when you use an adapter.
Others
Auto off
This system automatically turns off when you do not use
it for approximately 20 minutes.
1 Press [SETUP] to select “AUTO OFF”.
2 Press [R, T] to select “ON” and then press [OK].
“A.OFF” is shown.
To cancel, select “OFF”.
Note:
This function does not work when you are in radio source or
when a Bluetooth
®
device is connected.
Bluetooth
®
standby
This function automatically turns on the system when you
establish a Bluetooth
®
connection from a paired device.
1 Press [SETUP] to select “BLUETOOTH STANDBY”.
2 Press [R, T] to select “ON” and then press [OK].
To cancel, select “OFF”.
Software version
You can check the software version of the system.
1 Press [SETUP] to select “SW VER.” and then press
[OK].
The software version is shown.
2 Press [OK] again to exit.
Audio cable
(not supplied)
Rear panel of
this main unit
DVD player (not supplied)
ENGLISH
SC-AKX18 P RQT9899-P EN.fm Page 13 Monday, April 14, 2014 10:41 AM
printing