Filter
Top Products
15
Radio operations
RQT5706
1
A
2
3
4
TUNER/ BAND
TUNE MODE
ST
TUNED
dB
MONO
TUNED
REW/3
FF/4
CLEAR
MUTING
FM MODE/BP
REV MODE
SOUND EQ
TUNE
MODE
FM MODE/BP
2
3
1
4
/ REW /
/ FF/
DOWN
UP
VOLUME
Listening to radio broadcasts
Press [TUNER/BAND] to select “FM” or “AM”.
The unit comes on automatically.
Every time you press the button:
FM
G
AM
Press [TUNE MODE] to select “MANUAL”.
Every time you press the button:
MANUAL
G
PRESET.
Press [g/REW/3] or [4/FF/f] to select the
frequency of the required station.
“TUNED” is displayed when a radio station is tuned.
“ST” is displayed when a stereo FM broadcast is being received.
Adjust the volume.
Auto tuning
Press and hold [g/REW/3] or [4/FF/f] for a moment until the
frequency starts changing rapidly. The unit begins auto tuning, stopping
when it finds a station.
•
Auto tuning may not function when there is excessive interference.
•
To cancel auto tuning, press [g/REW/3] or [4/FF/f] once
again.
If noise is excessive in FM
by remote control only
Press [FM MODE/BP] to display “MONO”.
This mode improves sound quality if reception is weak, but broadcasts
will be heard in monaural.
Press [FM MODE/BP] again to cancel the mode.
“MONO” goes out. MONO is also canceled if the frequency is changed.
Turn off “MONO” for normal listening. Stereo and monaural broad-
casts are automatically played as they are received.
FM allocation setting
By adjusting the allocation, you can enable this tuner to receive FM
broadcasts allocated in 0.1 MHz steps.
Press and hold [TUNER/BAND]. After a few seconds, the display will
change to a flashing display of the current minimum FM frequency.
If you continue to hold the button down, the minimum frequency will
change. Release the button at this time.
To return to the original frequency indication, repeat above.
Note
•
After changing the “allocation” setting, the frequencies you previously
preset in the memory will be cleared.
•
Sound is momentarily interrupted if you load/unload tapes while
listening to an AM broadcast.
A