Filter
Top Products
25
RQT6924
Radio operations
The radio
Manual tuning
1 Press [TUNER] to select “FM” or
“AM”.
2 Press [6] or [5] to select the
frequency of the required station.
TUNED: Displayed when a radio station
is tuned.
ST: Displayed when a stereo FM broadcast
is being received.
Press and hold [6] or [5] until the frequency starts
scrolling to start automatic tuning. Tuning stops when a
station is found.
3 Adjust the volume.
SA-DT310
SELECT
DIGITAL
INPUT
Í
/I
AV CONTROL RECEIVER
DOWN UP
VOLUME
Ë
AUDIO ONLY
AV SYSTEM
SLEEP
GROUP
REPEAT/
MIX 2CH
PLAY MODE/
P.MEMORY
CANCEL
SKIP
CH
TOP MENU
DISPLAY
VOLUME
MUTING
FL DISPLAY AUDIO ONLY C.FOCUS
C.S.M
SFC
SUBWOOFER
LEVEL
CH SELECT
TEST
DELAY TIME
RETURN
TV VOL
s
TV VOL
r
DIRECT
NAVIGATOR
PLAY LIST
MENU
SLOW/SEARCH
S
10/
-
/
--
123
456
78
0
9
TV/AV DVD
TV VCR
CD
AUX EXT
ENTER
PL
RDS
DOUBLE
RE-MASTER
FM MODE
TUNER
SELECT
FM MODE
SETUP
TUNER
BAND
SLOW/SEARCH
6, 5
VOLUME
VOLUME
s r
3, 4, 2, 1
ENTER
TUNED
ST
∫ If noise is excessive in FM
Press [FM MODE] to display “MONO”.
Press [FM MODE] again to cancel the mode.
The mode is also canceled when you change the frequency.
∫ AM frequencyl step
[For[
Southeast[Asia
[
Main unit only
The step is factory-set to 9 kHz, but you can change it to receive
broadcasts allocated 10 kHz steps.
1 Press [SELECT] to select “AM”.
2 Press and hold [SELECT].
After a few seconds the display changes to show the current
minimum frequency. Continue to hold the button down. The
minimum frequency changes and the step is changed.
To return to the original step, repeat the above steps.
Note
Any AM frequencies preset in channels will be changed by this
procedure. Preset them again.
Preset tuning
Preset channels to make selection simple.
Up to 39 stations can each be set in the FM and AM bands.
Automatic presetting
1 Tune to “FM 87.50” (➡ left).
2 Press and hold [ENTER].
Release the button when “AUTO MEMORY” appears.
The tuner presets all the stations it can receive into the
channels in ascending order.
“SET OK” is displayed when the stations are set. The last
station to be set is then played.
3 Tune to “AM 522” (or “AM 520”).
4 Press and hold [ENTER].
∫“ERROR” is displayed
Presetting was unsuccessful. Preset manually.
Manual presetting
1 Tune to the station (➡ left).
2 Press [ENTER].
3 Press [3,4] to select a channel.
4 Press [ENTER].
The station occupying a channel is erased if another station is preset
in that channel.
MONO
FM 87.50
ME CH