Filter
Top Products
Simple setup
9
RQT6387
[DT300] ]DT100]
Attaching to a wall
Center and surround speakers can be attached to a wall.
Set the speaker onto screw and slide through bracket to lock into
position.
Note
The wall or pillar on which the speakers are to be attached should
be capable of supporting 10 kg per screw.
Attaching to speaker stands
Ensure the following conditions are met when you purchase your
speaker stands.
≥Observe the diameter and length of the screws and the distance
between screws as shown in the diagram.
≥The stands must be able to support over 10 kg .
≥The stands must be stable even if the speakers are in a high
position.
3 Attach the spikes and speaker feet to the bases of the front speakers.
These help stop the speakers from moving due to vibration and also change their angle.
To protect surfaces from scratching
1. Adhere two pads together. 2. Place the pads under the spikes.
≥If you put the speakers in a position where it is not appropriate to attach the spikes, attach speaker feet in ther place.
≥Use speaker feet for the remaining speakers.
≥You can set the surround and center speakers up at an angle by attaching two large speaker feet to the front.
≥Remove the seals from the adhesive surfaces of the spikes and
speaker feet.
≥Be sure to attach the spikes to the front of the speaker's base.
To face up
Speaker net
Sheet of
speaker feet
(small )
Spikes
Pads
Adhesive
surface
30–35 mm
7.5–9.5 mm
7–9 mm
Speaker feet
Speaker feet
Screw
(not included)
Attach the stands
with these holes.
5 mm,
pitch 0.8 mm
Plate thickness
plus 7 to 10 mm
Speaker stand
(not included)
60 mm
Base
Sheet of
speaker feet
(small )
Sheet of
speaker feet
(small)
Sheet of
speaker feet
(large)