Filter
Top Products
13
RQT6501
@@00
Standby/on button [POWER 8]
Press to switch the unit from on to standby mode or vice versa.
In standby mode, the unit is still consuming a small amount of power.
@@11
[INPUT SELECTOR]:
To select the input source
!0
@@22
[FM MODE]:
Press to switch to monaural mode if FM reception is poor !8.
@@33
[MEMORY]:
To preset radio stations !8
@@44
[TUNE MODE]:
To allow preset channel selection with [2 TUNING 1] !9
@@55
Remote control signal sensor
@@66
Standby indicator [^]
When the unit is connected to the AC mains supply, this indicator
lights up in standby mode and goes out when the unit is turned on.
@@77
[WAKE]:
Lights when the unit is in standby mode and the wake timer is set @0.
@@88
[–MULTI DECODER–, DOLBY DIGITAL, DOLBY
PRO LOGIC
22
, DTS]:
Light to indicate the source’s input signal and decoding format used.
DOLBY DIGITAL: Dolby Digital sources
DOLBY PRO LOGIC
22
:
Dolby Pro Logic 2 decoder is being used
DTS: DTS sources
@@99
[DIGITAL INPUT]:
Lights when digital input is selected
!0
.
##00
[VOLUME, p , o]:
Volume control and display. p DOWN and o UP light while adjusting
the volume
!0
.
##11
[PHONES]:
Headphone jack
Plug type: 6.3 mm ( 1/4") stereo
¡Avoid listening for prolonged periods of time to prevent hearing
damage.
¡The STEREO mode is engaged when you connect headphones
and you cannot select any of the other sound modes.
##22
[2 TUNING 1]:
For tuning the radio and selecting preset stations !8
Main unit
##33
[SURROUND, SFC]:
Show the current sound mode
!1
.
##44
[LFE, LS, L, C, R, RS, S]:
Show the channels contained in the digital input signal. They do not
light when input is analog.
LFE (Low Frequency Effect): Deep-bass effect.
LS: Surround channel (left)
L: Front channel (left)
C: Center channel
R: Front channel (right)
RS: Surround channel (right)
S: If the surround channel is monaural.
##55
[˜]:
Memory indicator, flashes during presetting !8.
##66
[TUNED]:
A station is tuned !8.
##77
[SLEEP]:
The sleep timer is on @0.
##88
[STEREO, MONO]:
STEREO: a stereo FM broadcast is tuned !8.
MONO: you have switched to monaural mode
!8.
##99
General display
Shows the input mode, radio frequency, and other general
information.
$$00
[kHz, MHz]:
kHz: AM, or PCM sampling frequency
MHz: FM
Display section
TUNED STEREO
MONO
kHz
MHz
SLEEP
SURROUND SFC
S
RSRCLLSLFE
M
28
33
34
38
39
40
32
VOLUME
DOWN
UP
p
·
·
·
·
·
·
·
o
25
26
27 29
30
31
21
22
24
23
36
37
35
20
Operations