Filter
Top Products
28
Using the Remote Control
The remote control works up to a distance of about 23 feet, and within a
30-degree angle on either side of the receiver. Point the control at the
receiver’s front panel and press the desired button(s).
Many buttons on the remote control work the same as buttons on the
receiver’s front panel. Use these buttons exactly as you would use the
corresponding buttons on the receiver.
CONTROL MODE Buttons
The
CONTROL
MODE
buttons select the device you want to control. The
remote control can operate the basic functions of your other audio/
video devices. Follow these steps to recall and program the remote con-
trol with the correct manufacturer’s code number for the device.
Note: Some brands have more than one code listed in the charts. If a
code does not work with your device, try another. The listed codes might
not work with all models from the listed manufacturers.
1. While holding
REMOTE SET UP
, press 1. All the
CONTROL MODE
buttons
start to flash and PUSHFUNC flashes on the display.
2. Press the
CONTROL MODE
button for the device you want to set the
code. For example, to set the code for CD player, press
CD
.
DVD/LD
: DVD or LD player
TV/SAT
: TV or satellite tuner
CD
: CD player/changer
MD/TAPE
: MD recorder or tape recorder
VCR1
: VCR or cassette deck
VCR2
: VCR or cassette deck
TV CONTROL
: TV or CATV tuner
The selected
CONTROL MODE
button lights steadily and the first
manufacturer name and its preset code appear alternately on the
display.
3. Repeated press ▲ or ▼ to display the name of the manufacturer of
your device. The selected manufacturer name and its preset code
flashes alternately. The list of all the available preset codes is
located in the back of this manual.
4. Point the remote control to the device desired, and enter the three-
digit code. The remote control sends the power on/off signal. If the
device turns on or off, you have set the correct code.
If the device does not turn on/off, press or to display other
codes for the selected manufacturer. If you try every preset code
and the device still does not function, you must use the original
remote control supplied with your device.
5. Press
REMOTE SET UP
to exit the preset mode.
You can clear all the programmed codes if necessary. Press
REMOTE SET
UP
and
0
at the same time for about three seconds until all the
CONTROL
MODE
buttons blink three times.
Using the Remote Control
DVD/LD
VCR 1
TV/SAT CD
TUNER
VCR 2
MD/TAPE
TV CONTROL
RECEIVER
DSP MODE
CH SELECT
ATT SIG SELECT
MIDNIGHT
TEST TONE
23
5
6
9
0
+10
MENU
TV/VCRCLASS
7
8
4
1
CHANNEL
CONTROL MODE
ENTER
VOL VOL
TUNE
TUNE
ASMS
+
–
TV FUNC
RECEIVER POWER
TV POWER
POWER
M
U
T
IN
G
CH LEVEL
EFFECT
DIMMER FUNCTION DIRECT
MODE CHECK
REMOTE
SET UP
Control
Mode
31-3046.fm Page 28 Monday, January 29, 2001 12:43 PM