Onkyo TX-SR701 Stereo Receiver User Manual


 
36
Conguring the speakers
Using the remote controller
1. Press the TEST button.
You will hear a pink noise which will be
emitted from the front left speaker.
(1) Remember the volume level of this noise and then press the CH
SEL button. The TX-SR601/601E will now emit the pink noise
from the center speaker.
(2) Using the LEVEL / buttons, adjust the volume level of the
noise from the center speaker so that it is at the same level as
that was emitted from the front left speaker.
(3) Press the CH SEL button again. The TX-SR601/601E will now
emit the pink noise from the front right speaker.
Use the LEVEL / buttons to adjust the volume of the noise
from the front right speaker so that it is the same level as that
was emitted from the center speaker.
(4) Use the CH SEL button to select other speakers and adjust the
volumes until all speakers are adjusted to the same level.
The pink noise level can be adjusted to anywhere between –12 and
+12 decibels for all speakers in 1-decibel increments. For
subwoofer, values between –15 and +12 dB can be set.
2. Press the TEST button to complete
the procedure.
You can change settings in the Setup Menu using the buttons on the
front panel and on the remote controller.
The buttons on the remote controller correspond to those on the TX-
SR701/701E/601/601E as shown below.
Buttons used for navigating through the menus
Buttons on remote controller
Buttons on TX-SR701/701E/
601/601E
Displaying the Main Menu and exiting the menu
Selecting a menu or menu item
Setting the value
Selecting the menu
Returning to the previous screen
SETUP SETUP
(upper edge of
ENTER button)
UP
(lower edge of
ENTER button)
DOWN
(left edge of
ENTER button)
LEFT
(right edge of
ENTER button)
RIGHT
ENTER ENTER
RETURN RETURN