Filter
Top Products
Advanced Settings
28
Setting item Default Value Setting Details
LPF of LFE 120Hz Set the low-pass filter for LFE (low-frequency
effect) signals in order to pass lower frequency
signals than the set value and thus cancel
unwanted noises. The low-pass filter will be
effective only on sources with LFE channel.
Set a frequency from "80Hz" to "120Hz".
"Off": Do not use this function
Double Bass On Boost bass output by feeding bass sounds from
the front left and right, and center speakers to the
subwoofer.
"On": Bass output will be boosted.
"Off (THX)": Bass output will not be boosted.
r The setting will not automatically be configured
even if you performed the automatic speaker
setup.
r If "Subwoofer" is set to "No" or if "Front" is set
to other than "Full Band", the setting cannot be
changed.
r If you're using THX-certified speakers, we recommend the following settings:
– Set a value "80Hz (THX)" in Crossover frequency.
– Set a value "80Hz (THX)" in LPF of LFE.
– Set a value "Off (THX)" in Double Bass.
Speaker Distance
Set the distance from each speaker to the listening position. Settings are automatically
configured if you use the automatic speaker setup.
Setting item Default Value Setting Details
Unit feet/meters Specify the unit of distance for configuring
settings.
"feet": When setting in feet (0.1ft to 30.0ft, in
increments of 0.1ft)
"meters": When setting in meters (0.03m to
9.00m, in increments of 0.03m)
Front Left 12.0ft/3.60m Specify the distance between each speaker and
the listening position.
Center 12.0ft/3.60m Specify the distance between each speaker and
the listening position.
Front Right 12.0ft/3.60m Specify the distance between each speaker and
the listening position.
Surround Right 7.0ft/2.10m Specify the distance between each speaker and
the listening position.
Back Right 7.0ft/2.10m Specify the distance between each speaker and
the listening position.
r The setting is not displayed if "Speaker
Configuration" - "Back" is set to other than
"None" and also "Back ch" is set to "1ch".
r This setting cannot be changed in any of the
following cases.
– "Speaker Settings" - "Front Speakers Type"
is set to "Bi-Amp".
– "Speaker Settings" - "Powered Zone 2" is
set to "Yes" and also Zone2 is set to on.
Back Left 7.0ft/2.10m Specify the distance between each speaker and
the listening position.
r The setting is not displayed if "Speaker
Configuration" - "Back" is set to other than
"None" and also "Back ch" is set to "1ch".
r This setting cannot be changed in any of the
following cases.
– "Speaker Settings" - "Front Speakers Type"
is set to "Bi-Amp".
– "Speaker Settings" - "Powered Zone 2" is
set to "Yes" and also Zone2 is set to on.