Filter
Top Products
Advanced Settings
33
LFE Level
Set the low-frequency effect (LFE) level of the Dolby Digital, DTS, Multichannel PCM, Dolby
TrueHD, DTS-HD Master Audio and DSD signals.
Setting item Default Value Setting Details
Dolby Digital 0 dB Select the low-frequency effect (LFE) level of
eachtypeofsignalfrom"0dB"to"-∞dB".Ifthe
low-frequency effect sound is too strong, select
"-20dB"or"-∞dB".
• This setting works on LFE channel volume of
Dolby Digital and Dolby Digital Plus sources.
DTS 0 dB Select the low-frequency effect (LFE) level of
eachtypeofsignalfrom"0dB"to"-∞dB".Ifthe
low-frequency effect sound is too strong, select
"-20dB"or"-∞dB".
• This setting works on LFE channel volume of
DTS and DTS-HD High Resolution sources.
Multich PCM 0 dB Select the low-frequency effect (LFE) level of
eachtypeofsignalfrom"0dB"to"-∞dB".Ifthe
low-frequency effect sound is too strong, select
"-20dB"or"-∞dB".
Dolby TrueHD 0 dB Select the low-frequency effect (LFE) level of
eachtypeofsignalfrom"0dB"to"-∞dB".Ifthe
low-frequency effect sound is too strong, select
"-20dB"or"-∞dB".
DTS-HD Master 0 dB Select the low-frequency effect (LFE) level of
eachtypeofsignalfrom"0dB"to"-∞dB".Ifthe
low-frequency effect sound is too strong, select
"-20dB"or"-∞dB".
Audio 0 dB Select the low-frequency effect (LFE) level of
eachtypeofsignalfrom"0dB"to"-∞dB".Ifthe
low-frequency effect sound is too strong, select
"-20dB"or"-∞dB".
DSD 0 dB Select the low-frequency effect (LFE) level of
eachtypeofsignalfrom"0dB"to"-∞dB".Ifthe
low-frequency effect sound is too strong, select
"-20dB"or"-∞dB".
• This setting works on LFE channel volume of
DSD (Super Audio CD) sources.
4.Source Setup
Adjust the volume level difference among the multiple devices connected to this unit,
rename an input selector, or adjust the image quality. The setting can be separately set to
each input selector button. When you select a desired input to check the video or audio,
start playback of the connected device.
AccuEQ Room Calibration
Setting item Default Value Setting Details
AccuEQ Room
Calibration
Off Enable/disable the sound field set in automatic
speaker setup
"On": Enable this function
"Off": Disable this function
• In the following cases, the setting cannot be
changed:
– Automatic speaker setup is not performed.
– Headphones are connected.
IntelliVolume
Setting item Default Value Setting Details
IntelliVolume 0 dB Adjust the volume level difference between the
devices connected to the unit. Select a value
between "-12 dB" to "+12 dB".
Set a negative value if the volume of the target
device is larger than the others and a positive
value if smaller.
• This function is not effective in Zone 2/Zone
3.